您要查找的是不是:
- choke valve body 阻塞阀体
- Remove the body bolts from the valve body. 从阀体上拆卸阀体螺栓。
- Lift retainer and check assembly from valve body. 从阀体内取出护圈和止回阀总成。
- Fill kill and choke valves with seawater. 将压井阀和阻流阀注满海水。
- Screw the cover onto the valve body. 将阀盖旋在阀体上。
- Turn handle to be perfectly perpendicular to valve body. 将手柄旋转到与阀体完全垂直的位置。
- The linkage rides to the end of the slot with enough force to break the choke valve away from the full-choke position. 连杆移动至槽的一端,用足够的力推动阻风门全部离开全阻风位置。
- However, the diaphragm provides more force to break the choke valve loose if it gets stuck. 不过,膜片提供的力更大,使风门一旦被卡住时,也能够打开。
- Remove the body bolts from valve body using Allen Key. 采用内六角扳手从阀体上拆卸阀体螺栓。
- Installation suggestion: valve body vertical and upward. 建议安装方式,阀体垂直向上。
- IMPORTANT! Flow must always be in direction of arrow on valve body. 重要提示!水流流向必须与阀体上的箭头方向一致。
- The carburetor obtains this enrichment by the addition of a choke valve in the carburetor throat above the venture and main nozzle. 所以在节气门和主喷管的上方增加了一个阻风门。
- Insert valve body through mounting hole and seat lugs. 将阀体插入安装孔和密封连接盘。
- Press stem/ball into valve body and remove from open end. 将阀杆/球体压入阀体内,并且从开口端卸下来。
- The top of retainer must drop just below threads in the valve body. 护圈上方必须放置在阀门阀体螺纹以下。
- Slide one half of the splash guard into the groove on the relief valve body. 将防溅保护的一半滑动到安全阀阀体的沟槽上。
- Install valve in the direction of the flow arrows on the valve body. 按照阀体上的箭头方向安装阀门。
- Assigning the ideally fitted wedge, ground and lapped, to proper valve body. 将研磨后的楔板分配到最适合的阀体上。
- Reinstall the valve body and union nuts only after the joint has fully cured. 只有在连接完全成功粘固后,才能够重新安装阀门阀体。
- Gear operator is removed by unscrewing hex head screws which hold operator to valve body. 通过拧松将操作机构固定在阀体上的六角螺栓来拆卸齿轮操作机构。