您要查找的是不是：
- calculated control signal 适当的控制信号
- The other host of signal are control signals. 另一组信号是控制信号。
- The response of a terminal to remote control signals. 终端对远程控制信号的响应。参阅handshaking。
- Expands the control signal for parallel steam generators. 使用并联的蒸汽炉时可用此配件扩大控制讯号。
- A control signal. 一个控制信号。
- Injector #2 output driver does not respond properly to the control signal. 喷嘴%232输出驱动器未对控制讯号作出正炒应。
- The default value is a calculated control name supplied by the Web Parts control set. 默认值是Web部件控件集提供的、计算出的控件名称。
- Injector #output driver does not respond properly to the control signal. 喷油器%237输出驱动器没有正确地响应控制信号。
- When you place a calculated control in the report header, the value is calculated for the entire report. 如果在报表页眉中放置一个计算控件,则计算的值是针对整个报表的。
- Design Of Programme - controlled Signal. 程控信号发生器的设计。
- For checking the evaluation device a control signal can be generated. 通过产生一个控制信号来检查核定设备。
- When you place a calculated control that uses the Sum aggregate function in the group header, the sum is for the current group. 如果将使用Sum聚合函数的计算控件放在组页眉中,则总计是针对当前组的。
- The main control cell adopt LPC936 singlechip, which offers the control signal. 其主控制单元采用LPC936单片机，提供控制信号。
- When you place a calculated control that uses the Sum aggregate function in the report header, the sum calculated is for the entire report. 如果将使用Sum聚合函数的计算控件放在报表页眉中,则计算后的总和是针对整个报表的。
- "Is the microetch rate monitored? Is it under SPC control with calculated control limits and are the charts & actions current? 是否对微蚀率进行监控？其是否有SPC图管控并有正在进行的措施？"
- Table 3-25 is a truth table of the 8251 bus control signals. 表3-25是8251总线控制信号的真值表。
- A logic element designed to act as either an adder or a subtracter in accordance with the control signal applied to it. 根据供给它的控制信号,或起加法器作用或起减法器作用的一种逻辑元件。
- The following screen shot shows the general layout of the calculator control. 下面的屏幕快照显示该计算器控件的常规布局。
- It carries the micro-processor control signal or "interface signals". 它用以传递微处理机的控制信号（或称“接口信号”）。
- You can then add the unbound and calculated controls that complete the design by using the tools in the Controls group of the Design tab. 然后再使用“设计”选项卡的“控件”组中的工具来添加未绑定控件和计算控件以完成设计。
