您要查找的是不是：
- LANDING GEAR BYPASS VALVE CONTROL. 起落架旁通活门控制。
- Remove the body bolts from the valve body. 从阀体上拆卸阀体螺栓。
- Lift retainer and check assembly from valve body. 从阀体内取出护圈和止回阀总成。
- Screw the cover onto the valve body. 将阀盖旋在阀体上。
- Turn handle to be perfectly perpendicular to valve body. 将手柄旋转到与阀体完全垂直的位置。
- Remove the body bolts from valve body using Allen Key. 采用内六角扳手从阀体上拆卸阀体螺栓。
- Installation suggestion: valve body vertical and upward. 建议安装方式，阀体垂直向上。
- Application of Combining Tech of Perforation With Passing Pressure by Bypass Valve and APR Test Tool. 旁通传压射孔与APR测试工具联作技术的应用
- IMPORTANT! Flow must always be in direction of arrow on valve body. 重要提示！水流流向必须与阀体上的箭头方向一致。
- Insert valve body through mounting hole and seat lugs. 将阀体插入安装孔和密封连接盘。
- Prepare suitable connection for 1?” threaded nipple provided in down stream of bypass valve for chemical feeding. 对在旁通阀下游装设的1?”螺纹接套准备合适的连接，以供化学进料。
- Press stem/ball into valve body and remove from open end. 将阀杆/球体压入阀体内，并且从开口端卸下来。
- The top of retainer must drop just below threads in the valve body. 护圈上方必须放置在阀门阀体螺纹以下。
- Turbine bypass hydraulic control system mainly consists of oil supply device, bypass valve hydraulic actuator, oil line and accessories. 汽轮机旁路液压控制系统主要包括：供油装置、旁路阀门液压执行机构、油管路及附件。
- The Eaton superchargers also use a bypass valve that equalizes the pressure on both sides of the impellers when the engine is operating in vacuum. 伊芳顿增压器也使用那使相等的阀门支路当发动机营运时，对叶轮的双方的压力在真空里。
- Slide one half of the splash guard into the groove on the relief valve body. 将防溅保护的一半滑动到安全阀阀体的沟槽上。
- The port labeled as Boost Port 2 is also a port that will provide access to boost pressure, but it is normally connected to the bypass valve actuator and should be left alone. 港口被给贴标签帮助港口2也是将提供进入的途径的一港口推进当时压力，但是它通常连接支路阀门作动器并且应该被单独留下。
- Water flow rate through terminal devices in an air condition water system with a single pump is controlled by the bypass valve when the air conditioning system is under part-load. 部分负荷时,单式泵变流量空调系统通过旁通阀控制流经末端设备的水流量,旁通流量的确定是正确选择旁通阀的前提。
- Install valve in the direction of the flow arrows on the valve body. 按照阀体上的箭头方向安装阀门。
- Assigning the ideally fitted wedge, ground and lapped, to proper valve body. 将研磨后的楔板分配到最适合的阀体上。
