您要查找的是不是：
- bus bar disconnecting switch 分段母线隔离开关
- SMC/DMC molded products: Widely used in electrical field such as bus bar clamp. 广泛地适用于电器制品，防眩板，母线夹，电表箱，井盖等制品。
- Switchgear mainly includes circuit breaker, disconnecting switch, load-break switch and fuse. 开关装置主要包括断路器、隔离开关、负荷开关和熔断器。
- Sway Bar Disconnected??????????? 摇动杆截断???????????
- The disconnect switch is the simplest switch on the basis of function, operating only in the absence of appreciable current. 按功能来讲,隔离开关是最简单的开关,仅在很小电流下操作。
- Bus Bar 200 meters west of Xuesi Lukou and Fourth Ring Road, south side of the roa d, Haidian. 公共汽车酒吧海淀区北四环路学四路口往南200米。
- Three-phase power supply box protection by fuse-controlled disconnect switch; Fuse-controlled command circuit protection. 保险（丝）控制关断开关或三相电源保护；保险（丝）控制操作电路保护
- The bus bar from one switchgear to the other switchgear is fixed with the bushing and the ramus bus . 母线从一个开关柜引至另一个开关柜，通过分支母线和套管固定。
- Route the power cable between the power disconnect switch and the melter and through the cable clamp.Tighten the cable clamp. 安装连接电源开关与喷胶机的线路并装上电缆夹，再固定电缆夹。
- This series are used for the containment of electrical equipments and for the connection of electric conductors as bus bar boxes. 这种箱体是用来放置电气设备和连接电线导体。如汇流排箱体。
- SCM received signal after Operational judgment, dealing with the situation and make the corresponding control Pick-up or disconnect switch signal output skid. 单片机接到信号后进行运算判断处理,并根据处理情况使对应的控制继电器吸合或断开输出打滑开关信号。
- Clean bus bar with cleansing and dry soft bibric, check insulation damage or no. According to 7.2 section state, clean lipa and feculence adhere to. 用清洁、干燥的软布擦拭母线，检查绝缘是否有损伤。按7.;2节所述，清除油脂和粘附的污物。
- When installation, unlade the join copper bus bar, through the preformed long-square hole, fixing it on the main grounding bus bar. 安装时将互连铜排卸下，穿越柜间预留的长方孔，固定在相邻两柜的主接地铜排上。
- Note: While the switchgear for different width are put together buder upon, the length of three phase bus bar is different, seeing about especially! 请注意：不同宽度的开关柜相邻拼接时，其三相母线的长度是各不相等的，在清点母线时，应特别留意！
- In circuit of connect to IGBT, the bus bar is employed, which is important way to reduce pass-voltage and mottle inductance. 为了减小杂散电感、抑制过电压,本文研究了功率母线的结构,并且应用在与IGBT直接相连的电路中,优化了主电路结构并减小杂散电感、降低过电压。
- When the phase bus bar all installing well, screw down all bolt according order with bushing-spanner and wring-spanner, main bus bar bolt's fastener power is 50 N. 待该相母线都安装就位后，再使用套管扳手及扭力扳手按顺序将每根螺栓拧紧，主母线螺栓的紧固扭力为50牛顿.;米。
- Voltage reactive power calculate,topology analysis of bus bar and several links of units reactive power distribution were carried out in AVC subsystem of power generation plants. 在发电厂自动电压控制(AVC)子系统控制中进行电压无功计算、电厂母线拓扑分析、机组无功分配的几个环节,采用了实用的、工程化的方法,简化了控制及计算并成功运用于现场的控制。
- LowVoltage Disconnecting Switch with Fuse 低压带熔丝隔离开关
- Running D/G set main bus bar has failure，Stand by D/G set can auto start and failure D/G set ACB is auto trip the ACB of stand-by generator can be auto closed. 在下列条件下，运行机组报警，备用发电机组应启动，运行发电机组分闸，备用机组合闸。
- high voltage load disconnecting switch 高压负荷切断开关
