您要查找的是不是:
- boundary layer edge 边界层边缘
- Sound Propagation in the Nocturnal Boundary Layer. 夜间边界层中的声传播。
- Boundary layer characteristics at the trailing edge of a tiltrotor blade model were measured using a flattened pitot probe and a single hot wire. 本研究以二体势能函数建立一套接触式原子力显微镜定力模式之模拟奈米级量测模型。
- Detection of Boundary Layer Water Clouds by Spaceborne Cloud Radar. 用机载云雷达探测边界层含水云。
- Beyond the boundary layer, the motion is highly irregular. 超出边界层以外,流体的流动非常没有规律。
- Formulation of Turbulent Fluxes in the Stable Boundary Layer. 稳定边界层中湍流通量算法。
- Stull, R.B., 1988: An introduction to boundary layer meteorology. 任平,2003:影响大气污染物散布的气象条件。
- As the air proceeds along the test section the boundary layer thickens. 当空气沿着试验段流动时附面层逐渐变厚。
- The Contribution of Shear to the Evolution of a Convective Boundary Layer. 切变对对流边界层演变的作用。
- A systematic study of TiO2 ceramic boundary layer capacitor (BLC) ismade. 本文对TiO_2陶瓷晶界层电容器进行了较为系统的研究。
- To solve this problem, a boundary layer suction test is carried out. 为此,本文采用附面层抽吸技术对其进行了地面抽吸状态下的流场控制试验研究。
- The bell reducer provides the cyclone action and the boundary layer control. 喇叭形异径管产生旋风作用并进行边界层控制。
- The evolution of vortexes in the boundary layer are numerically simulated. 本文数值模拟了多涡结构在边界层中的非线性演化过程。
- ZTFB photosensitive seal layer edge bonding machine is a special machine, which uses bonding die cavity to electric perm and spin to avoid ink infiltrate. ZTFB型光敏机印章垫封边机是利用封边模腔对光敏垫周边进行电烫,旋压,使印章与章壳周端边熔为一体,阻止印墨向外渗漏的一种专用机器。
- A separation in the boundary layer of fluid about a moving streamlined body, such as the wing of an airplane, causing a breakdown in the smooth flow of fluid and resulting in turbulence. 气流分离移动的流线型的躯体上流体边界层上的分隔物,如飞机的机翼,在平滑的流体流动中会引起故障和湍流
- Also, considering the disturbance action of solid grain to boundary layer, disturbance factor is cited. 又考虑到固体颗粒对边界层的扰动作用,引入了扰动因子。
- The example of most concern is the boundary layer next to the ground produced by the wind blowing over it. 最有意义的例子是风吹过地面时在地面附近产生的边界层。
- The boundary layer thickness is a function of the convection condition, in the melt. 边界层厚度是溶体中对流条件的函数。
- It was proved that the tracking error converges to the prescribed boundary layer and all the signals in the closed-loop system were bounded. 算法保证闭环系统所有信号的有界性且使得跟踪误差收敛于任意设定的饱和层内。
- In order to minimize the boundary layer effects, the nozzles were made as short as possible. 为了减少附面层效应,喷咀做得尽可能地短些。