您要查找的是不是:
- To be reversed any two wire can be changed motor direction. 調換任意兩相接線即可改變電機旋轉方向。
- Don't connect up the two wires, or there will be a short circuit. 不要把這兩條電線接在一起,否則會短路的。
- The2- wire interface is a widely used Master, multi-slave protocol using a serial clock( SCL) and a serial data line( SDA). 此2線介面是一個廣泛使用的主機、用串列時鐘(CL)串列數據線(da)多從機協議。
- Processing two wires at th same tine as necessary. 可同時加工兩條線。
- Make sure that the two wires are not touching. 務必使這兩根電線相互不接觸。
- Make sure.that the two wires are not touching. 務必使這兩根電線相互不接觸。
- Make sure? that the two wires are not touching. 務必使這兩根電線相互不接觸。
- Lower the overhead console far enough to access the two wire harness connectors. 降低正頂控制台,使得能接觸到兩個線束的接頭。
- A two wire SYSTEM then requires two twisted pair, and a four wire SYSTEM requires three twisted pair. 一個二線制系統兩個雙絞雙絞線對,一個四線制系統需要三個雙絞線對。
- The seat ring may be removed and replaced by pulling out the two wire retainers. 通過取出兩個線圈固定器可以拆卸和更換。
- When you contact these two wires, the machine will start at once. 當你使這兩條導線一接觸,這台機器就會立刻開始運轉。
- The mass difference is the main reason for the different implosion behavior of the two wire arrays. 線質量的差異是導致兩者內爆行為差異的主要因素。
- No current will flow until you connect the two wires up. 把這兩根電線連接起來才會有電流。
- If there are two wire screen angle consistent color separation, you must receive the moire, have to change the angle of the wire. 如果網線上有兩色版網線角度不合歧,則肯不退呈現龜紋,務必保持網線角度。
- Don't connect up the two wires,or there will be a short circuit. 不要把這兩條電線接在一起,否則會短路的。
- A circuit arrangement for deriving a phantom circuit. In four wire circuits, the two wires associated with the "GO" channel form one "side circuit", and those associated with the "return" channel form another. 用來派生一個幻象電路的電路結構。在四線電路中,與「去程」通道相關聯的兩線就形成了一個「半邊電路」, 而與「回程」通道相關聯的兩線構成了另一個「半邊電路」。
- The two wires were touching. 那兩條金屬線搭在一起了。(《牛津高階英漢雙解詞典》)
- Touch the ohmmeter probes to the two wires sticking out of the dry sand. 將歐姆表探針連接到插入乾燥沙子中的兩條電線上。
- Two wires for the supply voltage and one for the receiver's R/C sum signal. 通常沒有被引出,所以我們要打開接收機找到其中的那個焊點,將它引出。