您要查找的是不是:
- Secondly, using TFM, a semi-analytical solution of thermal stress problem of thickcylindrical shells is proposed. 其次,應用傳遞函數方法對厚壁圓筒的熱應力問題進行了半解析求解;
- Combined with DDA, the equivalent initial stress method is presented to solve the thermal stress problem of jointed rockmass. 結合非連續變形分析方法,提出了一種研究節理岩體熱應力問題的等效初應力方法。
- By this method,the thermal stress problem in ortho-anisotropic medium can be directed solved from the existing solution of lateral bending problem and vice versa. 利用本方法,正交各向異性材料中的平面熱應力問題的解可以直接從相同材料、相同幾何尺寸的板彎問題的解中得到,反之亦然。
- DDA METHOD OF THERMAL STRESS PROBLEM FOR JOINTED ROCK MASS 節理岩體熱應力問題的非連續變形分析方法
- DISCUSSION ABOUT THE THERMAL STRESS PROBLEM IN DDA METHOD 關於DDA中推導熱應力問題公式的討論
- New concept and new techniques for solving the thermal stress problem in the heightening of concrete gravity dam 解決重力壩加高時溫度應力的新思路和技術
- coupled thermal stress problem 耦合熱壓力問題
- We now illustrate the entire procedure in solving a plane stress problem. 我們現在來舉例說明解一個平面壓力題的全部過程。
- What kinds of thermal stress are there in the reactor? 在反應堆里有哪一種熱應力?
- Conduct material Fatigue Testing and Thermal stress test. 進行材料疲勞測試和熱應力測試。
- Thermal Stresses Due to Temperature Transients. 溫度轉變引起的熱壓力。
- The problem of thermal stress and a need for temperature control in the mass concrete construction also occur in the roller compacted concrete dams(RCCD). 大體積混凝土的溫度應力問題與溫度控制要求在碾壓混凝土壩中同樣存在。
- Study on Modeling of Rotor Thermal Stress with Varying Coefficients. 汽輪機轉子熱應力自適應模型研究。
- The edge stress problem in composite laminates under uniform axial extension is analyzed. 研究複合材料疊層結構在單軸拉伸狀態下的邊緣應力問題。
- The thermal stress can be mitigated effectively when P is 1 and n is 6. 隨著梯度層數的增加, 熱工作熱應力的最大值逐漸減小, 但當梯度層數達到6時, 隨著梯度層數的增加, 緩和效果並不明顯;
- These withstand heavy loads and thermal stresses well. 它們能很好地耐受重負荷和熱應力。
- In this paper, an approximate expression for solving plane stress problem of orthotropic material is worked out based upon the procedures of Lecknitzky's work. 本文在列赫尼茨基方法的基礎之上提供一個正交各向異性彈性平面應力的近似計算方法。
- In this paper, the point stress of different length oraoks in bandsaw teeth is calcuiatcd, according to the basic theory of plane stress problem of finite element method. 根據彈性力學平面應力問題有限元法基本理論,對帶鋸條鋸齒上不同長度裂紋尖端應力進行了計算,在此基礎上,研究與分析了帶鋸條的裂紋對斷裂強度的影響。
- Both transient and steady-state thermal stress can be determined by this procedure. 瞬態和穩態的熱應力均可用這種方法測定。
- The progress of thermal stress analysis of the FGM is reviwed and the development trends in this area are prospected in this paper. 回顧了近年來梯度功能材料(FGM)熱應力研究領域所取得的研究成果,並對FGM熱應力研究的發展趨勢作一展望。