您要查找的是不是:
- Check the engine oil level regularly. 要時常檢查機油量。
- Through the oil level indicator, we check the hydraulic oil level of crane. 利用油位指示器檢查起重機的液壓油位。
- Inspecting the oil level of motor lubrication. 檢查發動機潤滑油油麵。
- Inspect the hydraulic oil level of clutch. 檢查離合器液壓油油麵。
- Add 2.0 litre5 to reach max.oil level! 添加2升以達到液位上限!
- A seal kit consists of two labyrinth seals and is supplied together with an oil pick-up ring, an oil level gauge, a magnetic plug and mounting instructions. 密封套件包含兩個迷宮密封件,在提供給用戶時還帶有一個拋油環、一個油位表、一個磁鐵油塞,以及安裝說明。
- Tip: If you don't know the oil capacity of the engine, add four quarts, then check the oil level, if it's a quart low add another quart. 冰山:如果你不知道發動機油容量;加上四個石英;然後檢查石油級如果是低再添一石英石英.
- If equipped with an oil level sensor, disconnect the sensor. 如果配備有油麵感知器,斷開感知器。
- Methods: to keep the crankshaft inside a normal oil level. 方法:保持曲軸箱內正常的機油水平。
- Message: Fixed: max security level check in. Security command, normalize player name and encode before use. Let apply this command to offline player. 修復最大安全等級檢查.;security命令;在使用之前規格化玩家名字和密碼;讓這個命令適用未連線的玩家。
- Sealed oil chamber does not require constant monitoring of oil level. 密封的油箱,不需要經常觀察油量的多少。
- It is important not to exceed the recommended oil level if leakage is to be avoided (table). 如果要避免漏油,不能超過建議的油量,這是很重要的,見表13。
- Oil level marks in the housing and an oil level gauge help to keep the correct oil level. 軸承座內的油位標記和油位表使油位保持在正確水平。
- Examine working status of the frame, degree of cleanness and oil level of lubricating oil termly. 定期檢查托架的使用情況,定期檢查潤滑油的清潔度和油位。
- There is no dipstick for the AL4 automatic transmission, and the level checking procedure is slightly unusual. 因為AL4自動波箱系冇油呎,所以檢查程序有多少特別。
- Fill oil pan 1 with JUKI Machine Oil No. 7 up to HIGH mark A.When the oil level lowers below LOW mark B, refill the oil pan with the specified oil. 請把JUKI Machine Oil No.;1機油倒進油槽1里,一直加到HIGH標記A的位置。油槽的油麵降到LOW標記B以下時,請再次補充機油。
- In this paper, fiber-reinforced epoxy foam composite used as floater for indicating height of oil level in automobile braking system was investigated. 研究了纖維增強環氧發泡材料用於轎車剎車油液面指示用浮子。
- (6) Check the oil level in the lubricator. 檢查注油器的油位。
- While simulating high oil temperature and high oil level failure conditions, the corresponding indicating lamp should light up and failure pre-warning messages should be sent out. 模擬油溫高、油位高故障,相應的指示燈亮且應有故障預報警信號輸出。
- Oil of reducer should be replaced every half year.The oil storage of reducer must be kept on prescribe oil level during operation and should not be too much. 走行減速機要定期更換潤滑油。每半年更換一次。運轉中,減速機體內儲油量必須保持規定油位,不宜過多或過少。