您要查找的是不是:
- Another ambient temperature sensor is the vapor-filled bellows. 另一種空氣溫度感測器是充氣波紋管。
- REPAIR HE OPEN AMBIENT TEMPERATURE SENSOR SIGNAL CIRCUIT. 修理開路的周圍溫度感知器信號電路。
- Film form-ing mechanism of ambient temperature blackening. 並重點對常溫發黑、化發黑、化發黑的成膜機理、層性能特點及應用情況作了說明。
- The ambient temperature under installation should not below00 C. · 電纜敷設時環境溫度應不低於00C。
- An ambient temperature cross-linkable emulsion was described. 介紹了一種可室溫交聯乳液。
- Another ambient temperature sensor is the vapor-filled bellows . 另一種空氣溫度感測器是充氣波紋管。
- Shelf life at ambient temperature, says Madsen, is two years. 貨架期在常溫下說,馬德森,為兩年。
- When the ambient temperature rises, the charge efficiency increases. 環境溫度升高,充電效率增加。
- Free from the influence of ambient temperature,it is stable and reliable. 不受環境溫度影響,穩定可靠。
- It is important that the ambient temperature for DIRC-5 is between 0 and 30 . 這是非常重要的環境溫度為dirc - 5介於0和30 。
- Repeat the zeroing process whenever the ambient temperature changes. 每當環境溫度變化時,都要重複消零操作。
- Keep Cold storages and Ambient Temperature warehouses are clean and in order. 負責保持胰島素冷庫和常溫倉庫乾淨整潔有序;
- Torque values apply to clean fluid at ambient temperatures. 扭矩值適用於常溫下的清潔液體。
- Hibernation may last several days or weeks depending on species, ambient temperature, and time of year. 冬眠也許持續數天或好幾星期,取決於物種、周圍的環境和年月時間。
- Locate the ambient temperature sensor, on the radiator support behind the grille. 找到位於散熱器柵板后的散熱器支撐上的環境溫度感知器。
- Storage: Clean, dry, at ambient temperature, away from odorous materials. Open bags must be properly re-sealed. 保存方法:清潔、乾燥、室溫下,遠離有異味材料。
- Stability of Water-in-Oil Emulsions Under Low to Ambient Temperature Cycling Conditions, Test Method for (05. 低於室溫循環條件下的油中含水乳液的穩定性的試驗方法(05。
- The results showed that the ambient temperature had some effect on sewage sludge compostingprocess. 結果表明:環境溫度對污泥堆肥過程的堆體溫度有影響。
- Chemical processes carried out at ambient temperature cannot be expected to operate rapidly. 在環境溫度下進行化學過程,不能期望它迅速地發生作用。
- Swelling and porosity of the propellant mixture became evident after 6 days at ambient temperature. 在室溫下將葯柱放置6天後,推進劑呈現膨脹和氣孔。