您要查找的是不是：
- These materials exhibit low strength. 這些材料具有低強度。
- Flux entrapped in the joints is the principal cause of low strength or failure. 裂縫中封存有焊葯是強度不足或斷裂的主要原因。
- A specimen of large size would have lower strength than a small sp... 計算還表明脆性體的強度隨微裂紋分佈函數標準方差的增加而減小。
- Controlled Low Strength Material (CLSM) is a self-compacted, flowable material. 可控制性低強度混凝土（CLSM）具備高度流動性以及自我填充之特性。
- When reassembling apply a drop of low strength thread lock to disc holder. 在重新組裝時,將一個低強度螺紋裝置鎖到閥瓣支架上。
- For moderate JI, lower strength and the behavior of jointed rock specimen are mainly governed by joint. 當節理傾角適中時，節理岩樣的峰值強度較低，岩樣的行為受控於節理。
- As addition of ash is 65%~75%,the building materials of lower strength,for example masonry cement and building mortar,can be produced. 飛灰摻量65%25~75%25時,膠砂強度顯示仍可生產一些低強度要求的建材產品,如砌築水泥、建築砂漿等。
- For example, BH steel under low strength is pressed and baking finish to improve its strength of extension. 例如BH鋼板是在低強度的條件下，經過衝壓成形之後，進行烤漆加工熱處理，以提高其抗拉強度。
- Gun Attack: This represents the early means of defeating your enemy's strength factor. It causes low strength damage. 艦炮攻擊:這是打擊敵人的早期方法。艦炮攻擊較低地打擊敵人的力量。
- polyvinyl formal high strength wire coating 聚乙烯醇縮甲醛高強度漆包線漆
- A widely used sealed material, but because of its low strength, it's better to use with other filling together. 是一種應用廣泛的密封材料，但因其強度低，與其它填料混合組裝使用效果好。
- High Strength Wire Cable Mesh and Polymeric Mortar 高強鋼絞線-聚合物砂漿
- ASTM D6103-97，2000，Standard Test Method for Flow Consistency of Controlled Low Strength Material（CLSM）. 內政部營建署，2002，控制性低強度材料（CLSM）產制及應用手冊，第47頁，財團法人台灣營建研究院。
- The different raw yarn sampling and test method effect on Nylon66 twist cord lower strength calculated value are investigated. 研究錦綸66原絲不同取樣方法和測試方法對捻織工序簾線強損值計算結果的影響.
- When replacing disc holder, apply a drop of low strength thread lock. Do not over torque. 當更換閥瓣支架時,輕微壓下螺紋鎖。不要過力。
- The shear behaviors of the low strength brick masonry wall strengthened with the self-compacting reinforce concrete wall have been discussed by 6 experimental models. 為研究自密實混凝土板牆加固低強度砂漿磚砌體的抗剪性能,共做了6個牆體加固試件。
- The results show that the main causes of fracture is composition segregation and low strength resut from no quenching and tempering treatment. 結果表明，產生斷裂的主要原因是材料內部成分偏析及未按要求對材料進行調質處理導致材料的強度較低。
- But it can not be used at some condition because it will be decomposed and becomes Al_2O_3 and TiO_2 , and it has low strength. 它在850℃-1280℃時會分解成Al_2O_3和TiO_2,並且其強度也很低,這兩個弱點嚴重製約了它的使用範圍。
- It was found that enzyme 188 scouring could impart cotton fabric lower strength damage and weight loss,better levelness,softer handle,and energy saving as well. 試驗證明,使用氧漂煮練酶188處理的織物,強力下降較小,失重率較少,勻染性好,手感柔軟,且節能降耗。
- It is especially for the low strength mattess;if equipped with sand paper sheet, it aslo can be used to grind epoxy putty layer. 特別適用於地面混凝土強度低的情況,如果配上砂紙磨片,也可以打磨環氧膩子層;
