您要查找的是不是:
- loopback module diagnostic 迴路組件特徵
- The network interface is a loopback adapter. 網路介面是環回適配器。
- Gets the index of the loopback interface. 獲取環回介面的索引。
- The Loopback Test could not be performed. 不能執行環回測試。
- All of your loopback devices are in use. 請問是怎麼會事?在使用的時候,無法生成另一個么?
- Object repository support for creating shared, reusable form and data module. 用於創建共享、可重用窗體和數據模塊的對象儲存庫支持。
- Stops, it stops all diagnostics it has started. 停止時將停止它啟動的所有診斷。
- Run hardware diagnostics and correct any problems. 運行硬體診斷以解決任何問題。
- Enable Diagnostics for Open Wire. 激活斷路診斷。
- See Diagnostics Symbol Store Interfaces. 請參見診斷符號存儲區介面。
- Click Continue, and then click Start Diagnostics. 單擊「繼續」,然後單擊「開始診斷」。
- A young Air Force officer served as lunar module pilot for Apollo 16. 一位年輕的空軍軍官擔任了阿波羅16號登月艙的駕駛員。
- Quest Diagnostics is a great example of this point. 探索診斷是一個這一個點的很棒例子。
- Replace module and reassemble valve. 更換模塊並重新組裝閥門。
- It's a systems diagnostics test. 一個系統的什麼?
- Note: Check the LED on the module. 注意:檢查模塊上的led指示燈。
- Diagnostics could not find any obvious problems. 診斷無法找到明顯問題.
- The DS1 remains OOS while the loopback is performed. 在執行迴環期間,DS1 會一直保持 OOS 狀態。
- Cannot set nonlocal hook without a module handle. 沒有模塊句柄無法設置非本機的掛接。
- To perform the loopback,the DS1 must be in the OOS state. 要執行迴環,DS1 就必須處於 OOS 狀態。