您要查找的是不是：
- Watch pressure drop on pressure gauge. 手錶壓力在壓力標準度量上降低。
- Valve exhibits high pressure drop. 閥門出現高壓降。
- Causes of too fast increase of the pressure drop and location in the fixed bed reactor of hydrocracker were discussed. 討論了加氫裝置固定床反應器壓力降升高過快的原因及產生的位置。
- Abstract: Causes of too fast increase of the pressure drop and location in the fixed bed reactor of hydrocracker were discussed. 文摘:討論了加氫裝置固定床反應器壓力降升高過快的原因及產生的位置。
- DID THE PRESSURE DROP TO 0 PSI AND A "NO DRIVE" CONDITION OCCUR? 壓力是否降至0PSI而且條件"NO DRIVE"出現?
- However, the pressure drop occurs almost completely in the plug. 然而，壓力降幾乎完全發生在多孔塞中。
- Drier operates in either flow direction with low pressure drop. 在任何一方向都可操作應用。
- Presents the theoretical model of pressure drop for flexible duct. 摘要介紹了柔性風管壓力損失的理論模型。
- They are commonly used where a minimum pressure drop is important. 通常用在要求壓降最小的應用場合。
- How to control the ranges of reheater steam temperature during fixed pressure and sliding pressure start-up? 在定壓起動和滑壓起動時如何控制再熱蒸汽溫度？
- Read the pressure drop across the valve with a Watts Series PG meter. 利用美國瓦茨系列PG儀器讀出通過閥門的壓降。
- For compressible fluids, where pressure drop exceeds half the inlet pressure. 對於可壓縮性流體,如果壓降超過進口壓力的一半。
- In the production of H.F. butt spiral welded pipe, the vertical roll extruding installation with fixed position are changed into horizontal roll installation with fixed pressure. 在高頻對接螺旋焊管試驗生產中，將恆位置立輥擠壓裝置改為恆壓力平輥裝置，對兩種裝置的摩擦參數進行了分析比較。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 對於不可壓縮性流體,如果壓降產生空穴或閃蒸。
- Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm. 調整平衡閥直到壓差表讀出壓降符合所要求的流量（加侖/分鐘）為止。
- The inventory of solids in a fluidized bed can easily be found by pressure drop measurements across the bed. 流化床內的固定藏量可以用測定床層的壓降辦法很容易地求得。
- Requirement: Supply pressure drop must be 1.0 PSID or more when water flow stops from test cock No. 2. 要求：當水流從測試旋塞2號上停止時，供應壓降必須在1.;0PSID及以上。
- In this range, the pressure drop increases in proportion to the specific gravity of the mixture. 在這個範圍內壓力差的增加與深水的比重成比例。
- When viscous forces predominate the flow is proportional to the pressure drop across the element. 當粘滯力起主導作用時，流量當通過主要部分的壓力降或正好。
- Type 7- 70% port opening, particularly suitable where small pressure drop is desirable. 類型7-70%25埠開啟度,特別適用於需要小壓降的應用場合。
