您要查找的是不是:
- Remove valve spring and retainer. 拆卸閥彈簧和扣件。
- CAUTION: The check valve spring is in compression. 警告:止回閥彈簧處於壓縮狀態。
- Smooth operation of throttle linkage and throttle body air valve. 節流連桿和節流體空氣閥的平穩操作。
- Unthread the pump from the air valve and measure sag. 參考氣壓設定建議數值表打入相應氣壓以達到所需的預壓行程。
- For removal of valve stem seal and lower valve spring guide. 可用於拆卸汽門油封或降低汽門彈簧。
- Equipped with air valve to ejecting the products by blowing. 配備吹氣裝置以便於脫模。
- Repeat steps2-5 until proper sag is achieved, then replace the air valve cap. 重複2-步驟以達到最佳預壓行程后,蓋上氣閥嘴帽。
- Repeat steps 2-5 until proper sag is achieved, then replace the air valve cap. 重複2-5步驟以達到最佳預壓行程后,蓋上氣閥嘴帽。
- Locate the Schrader air valve on the shock and remove the air valve cap. 找到避震上的美嘴氣閥,取下氣閥帽。
- Due to the release of pressure when removing the cover, the relief valve spring may eject quickly. 因為在拆卸閥蓋時鬆開壓力,安全閥彈簧可能會快速彈出來。
- Multi - purposed optimal design of reliability for valve spring based on fuzzy method. 基於模糊學方法的氣門彈簧可靠性多目標優化設計。
- An overall air control for each pipe in each room is available by fitting an air valve at the hot water supply. 把空氣閥安裝在溫水供給器時可綜合處理各房間管路內的空氣。
- Remove the relief valve cover, stem/diaphragm assembly, and relief valve spring. 拆卸安全閥閥蓋,閥桿/隔膜總成,和安全閥彈簧。
- Screw the FOX Racing Shox High Pressure Pump onto the air valve until the pump shows pressure on the gauge. Do not over-tighten. 把避震專用打氣筒旋緊在氣閥上直到避震氣筒上的壓力表有氣壓顯示,不要過份旋緊。
- Install a dial indicator so plunger contacts valve spring retainer as nearly perpendicular as possiblZero the indicator. 安裝一個錶盤式指示器,使柱塞與氣門彈簧護圈儘可能垂直。將指示器調零。
- AIR VALVE IS MADE UP OF UPPER VALVE SEAT, LOWER VALVE SEAT, 5 KINDS OF ACCURATE VALVE SLICE AND 25 SPRINGS. 該氣閥是由上閥座、下閥座及大小5種精密閥片和25個彈簧等零件組成。
- Check whether or not the fuel injection pump plunger and fuel outlet valve is worn or clogged, plunger spring and fuel outlet valve spring is broke. 噴油泵柱塞及出油閥是否磨損或卡死、柱塞彈簧及出油閥彈簧是否折斷;
- Technician was adjusting air valves on pallet elevator behind the safety guard. 該技工實際上是在調整安全裝置後面的托盤貨物升降機的氣閥。
- Then, pneumatic valve spring made from this spring steel wire have been treated by this investigation of liquid tufftriding process. 然後 ,用以對此規格的鋼絲製造的氣閥彈簧進行了低溫液體軟氮化處理。
- Air valve and piston-type compressors are to the important components is one of the components easily damaged. 氣閥是往複活塞式壓縮機中的重要部件,也是易損壞的部件之一。