您要查找的是不是:
- Based on ERICSSON GSM base station transceiver principle,the matching and stability of RF amplifier performance are analyzed in term of circuit structure. The advantages of ERICSSON GSM base station are presented. 基于爱立信公司的GSM基站收发信机原理,从电路方面对射频放大器进行了匹配分析和稳定性分析,说明了爱立信公司的GSM基站的一些特点。
- Analysis of power amplifying circuit in GSM base station transceiver GSM基站收发信机中的功率放大电路分析
- base station transceiver 基站收发端
- NCO is an important part in software radio transceiver of CDMA base station. 数控振荡器 (NCO)在 CDMA基站的软件无线电收发机中 ,起着非常重要的作用。
- Base Station Destroy all enemies to advance! 消灭所有敌人过关。
- Enter the base station password if necessary. 如有必要,请输入基站密码。
- Too far away from the nearest base station. 因为距离最近的基站太远了。
- It utilises the LED flash unit of the regular base station. 照相机使用普通底座的LED闪光灯。
- Interpreted presentation of base station fault and alarm status. 翻译基站故障和告警状态的表示。
- Remove an RCS to take the RCS and attached base station out of service. 退出某个 RCS 以使该 RCS 及附加的基站退出服务。
- Nearby base stations using adjacent channels. 使用相近频道的相邻基站。
- Plug the hard disk into the USB port on the back of the base station. 将硬盘插入到基站背面上的USB端口。
- LEMP is a very important factor of EMI for the Base station of WLAN. 雷击电磁脉冲(LEMP)是远程无线局域网基站的重要电磁干扰(EMI)因素。
- The sectored array antenna is applied to the base station of TD SCDMA. 该天线阵列用于TD SCDMA基站系统中。
- The microbrowser on the wireless device sends a request to the wireless network base station. 无线设备上的小型浏览器向无线网络基站发送一个请求。
- The request is sent from the base station over the wireless network using the Wireless Transport Protocol (WTP). 基站发出请求,使用无线传输协议(WTP) 在无线网络中传输。
- The Remove button is used to disconnect all attached base station sites from the MSC. Remove 按钮用来从 MSC 断开所有附加的基站。
- If you try to remove a DS0 for which the end point connection_ base station or CDM_is in service,the remove fails. 如果试图要使某个端点连接--基站或 CDM--处于服务中的 DS0 退出服务,则退出服务失败。
- If you try to remove an AP DS0 for which the end point connection_ base station or CDM_is in service,the remove fails. 如果试图要使某个端点连接--基站或 CDM--处于服务中的 DS0 退出服务,则退出服务失败。
- During a switchover,the connections remain established between the AP and the base station signaling links. 在切换期间,仍会保持 AP 和基站信令链路间建立的连接。