您要查找的是不是:
- axle drive pinion shaft 车轴主动小齿轮轴
- axle drive pinion adjusting sleeve 车轴传动小齿轮调整套
- Remove the universal joint strap bolts at the pinion shaft yoke. 在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
- Refer to Drive Pinion Bearing Pre-Load Adjustment. 参阅驱动小齿轮轴承预荷调整。
- Worn teeth on ring gear or drive pinion gear. 环形齿轮或驱动小齿轮上齿磨损。
- Hold the yoke with Wrench 67Remove the pinion shaft nut and washer. 用扳手6719握住轴轭。拆下小齿轮轴螺帽和垫圈。
- End play in drive pinion bearings. 驱动小齿轮轴承的端隙。
- The pinion shaft runs in porous bronze bearing bushes. 小齿轮轴运行多孔青铜轴承衬套。
- The drive pinion is beveled at 45 degrees and engages the ring gear, which is also beveled at 45 degrees, causing the ring gear to revolve at 90 degrees to the drive shaft. 该驱动器齿轮是斜45度和参与的齿圈,这也是斜角在45摄氏度,造成齿圈旋转90度的传动轴。
- Seal air is injected into the labyrinth seals located at the main motor shaft (top and bottom) and at the pinion shaft driving the motor. 密封空气被注入到主马达轴(顶部和下部)和驱动马达的齿轮轴的迷宫式密封里。
- "COMBO DRIVERS " the means from the metaphrase on literal " coupled axle drive implement " , it is used to to call by people " Kang Bao " . “COMBO DRIVERS”从字面上直译的意思是“组合驱动器”,它被人们习惯称为“康宝”。
- differential spur drive pinion cross shaft 差速[减速]器主动齿轮横轴
- In fact, as early as 1996 gnandou lavins in the United States to install a 52-inch (approximately 1.32 m) wide color achromatous axle drive gravure press. 原来,早在1996年杜文斯不离在美国安设了一台52英寸(约1.;32米)阔的宾色无色轴驱动瘪印机。
- A pinion shaft, the rack shaft, and a rack guide holder are assembled in a housing, and an adjust screw is strongly tightened to press the rack guide holder toward the rack shaft under an overload. 齿轮轴、齿条轴和齿条导向支架安装于壳体内,并且调节螺杆在载荷作用下非常紧地将齿条导向支架压向齿条。
- Flexible axle driven system which drive the rotor directly, smooth in operation、low noise and small vibration. 电机采用柔性轴驱动系统直接传动转头,运行平稳,振动小,噪音低。
- The ring gear is attached to the differential case so that the ease rotates with the ring gear when the latter is driven by the drive pinion. 冠状齿轮与差速器壳相连,这样当冠状齿轮由传动齿轮驱动转动时,差速器壳也转动。
- An over-running clutch on the drive pinion prevents the starter from being driven by the engine once it starts. 在驱动小齿轮上的一个超转离合器可避免启动马达被引擎带动,一旦引擎启动了。
- wheel cylinder adjusting pinion shaft 轴闸储气筒调准小齿轮轴
- The part of a machine shaft or axle supported by a bearing. 轴颈机械的转动轴或轮轴中由轴承所支撑的部分
- It has been provided by practice that one of the problems, which constrains the development of multi axle drive vehicles, is the rational distribution technique of the driving torque. 实践证明,制约多轴驱动车辆发展的问题之一是驱动扭矩的合理分配技术。