您要查找的是不是：
- application valve body 控制阀体
- Remove the body bolts from the valve body. 从阀体上拆卸阀体螺栓。
- Lift retainer and check assembly from valve body. 从阀体内取出护圈和止回阀总成。
- Screw the cover onto the valve body. 将阀盖旋在阀体上。
- Turn handle to be perfectly perpendicular to valve body. 将手柄旋转到与阀体完全垂直的位置。
- Remove the body bolts from valve body using Allen Key. 采用内六角扳手从阀体上拆卸阀体螺栓。
- Installation suggestion: valve body vertical and upward. 建议安装方式，阀体垂直向上。
- IMPORTANT! Flow must always be in direction of arrow on valve body. 重要提示！水流流向必须与阀体上的箭头方向一致。
- Insert valve body through mounting hole and seat lugs. 将阀体插入安装孔和密封连接盘。
- Press stem/ball into valve body and remove from open end. 将阀杆/球体压入阀体内，并且从开口端卸下来。
- The top of retainer must drop just below threads in the valve body. 护圈上方必须放置在阀门阀体螺纹以下。
- Structure of coke oven bridge pipe and valve body are introduced,in which several structures are respectively reviewed.Notices for application and design are put forward. 介绍了炼焦炉中桥管与阀体结构的形式，分别对几种结构形式加以评述，指出了今后设计时应注意的问题。
- Slide one half of the splash guard into the groove on the relief valve body. 将防溅保护的一半滑动到安全阀阀体的沟槽上。
- Install valve in the direction of the flow arrows on the valve body. 按照阀体上的箭头方向安装阀门。
- Assigning the ideally fitted wedge, ground and lapped, to proper valve body. 将研磨后的楔板分配到最适合的阀体上。
- Reinstall the valve body and union nuts only after the joint has fully cured. 只有在连接完全成功粘固后，才能够重新安装阀门阀体。
- Gear operator is removed by unscrewing hex head screws which hold operator to valve body. 通过拧松将操作机构固定在阀体上的六角螺栓来拆卸齿轮操作机构。
- rubber gasket of application valve 应用阀胶垫
- This construction avoids the need for extending the pivot pins through the valve body. 这种结构消除了将枢轴销伸长穿出阀体的必要性。
- Install new retainer module assembly into valve body by aligning "U" shaped cutout in retainer with the valve outlet. 通过对齐护圈上和阀门出口的"U"形切口，将新的护圈模块总成装配到阀体内。
