您要查找的是不是：
- apparent shear stress 表观切应力
- Critical resolved shear stress (O’crss). 临界分剪切应力。
- Influences of composition of the blends, shear ratio, shear stress on swell ratio and melt apparent viscosity were discussed. 讨论了共混物的组成、剪切应力和剪切速率对熔体粘度和膨胀比的影响。
- The shear stress and apparent viscosity of the masterbatch decreased with the increase of the shear rate and temperature. 随着剪切速率的增加,温度升高,剪切应力会降低,母粒的表观黏度也随之降低。
- CMC,salt and xanthan gum enhance the shear stress of lotus root starch paste significantly,and increase the apparent viscosity a little. CMC、食盐、黄原胶使莲藕淀粉糊的剪切应力明显提高,表观黏度稍有增大。
- But Mooney viscosity showed different relation with carbon black content in comparison with apparent shear viscosity. 相对分子质量分布较宽时(BR9002),门尼粘度和表观剪切粘度较低。
- Comparin g to neat system with no nanosilica,results of rheological measurements showed that the biggest dynamic apparent viscosity,the biggest shear stress and thixotropy index of CSN were improved about 40times,about 40times and 67.36%,respectively. 流变性能测试表明:纳米SiO2加入体系后;体系的最大动态表观粘度、最大剪切应力和触变指数分别提高了约40倍、约40倍和67.;36%25;
- The interfacial shear stress is a constant proportion of the bottom shear. 交界面的剪力与底部剪力之比是常数。
- The process does not affect the shear stresses. 这样的处理并不影响剪应力。
- The rheological properties of chlorosulfonated polyethtylene (CSM),especially the effect of the shear rate,shear stress and temperature on the apparent viscosity of CSM melt,were investigated. 研究氯磺化聚乙烯 (CSM )的流变性能 ,特别是剪切速率、剪切应力和温度对CSM熔体表观粘度的影响。
- According to the twin shear stress theory, this paper improves on Duncan Model. 根据双剪应力理论对邓肯模型进行了修正。
- Tensile stress and shear stress are transferred by PBL shear connectors. 计算得到钠-混凝土接头的最不利荷载组合内力。
- A fluid is a substance that deforms continuously under an applied shear stress. 液体在剪应力作用下不断变形？？
- The main shear stress and its hydraulic system, calculation and research. 主要对其剪切力和液压系统进行计算和研究。
- Thus fluid shear stress has been considered one of the atherogenic factors. 在动物研究中还发现切应力与内皮细胞增生程度有关。
- With gob span increasing, equivalent shear stress in basic roof increases. 随着采空区跨度的不断增加，基本顶等效剪力不断增大。
- The shearing stress of the composite rises with increasing of shielding agent loading and so does the apparent viscosity. 随屏蔽剂含量的增加，混合料表现出更高的剪切应力，其表观粘度也相应增加。
- The results show that the shearing stress rises and the apparent viscosity of composite reduces with increasing of shearing rate. 结果发现，随剪切速率的增加，其剪切应力提高，而表观粘度下降。
- Draw the element for maximum shear stress and mark values of all stresses. 画出最大剪应力的单元体并标出全部应力值。
- Friction and cohesion are best defined in terms of the plot of shear stress versus normal stress given in Figure 9. 摩擦角和粘结力最好是根据图9中剪切应力和法向应力的关系曲线确定。
