您要查找的是不是：
- anneal treatment after cold drawing 冷拉后退火处理
- Effects of annealing treatment on physical properties of a dental all-ceramic system. 退火处理对牙科全瓷冠物性的影响.
- The microstructure of different annealing treatment for TWIP steel before and after tensile deformation was investigated by static and TEM. 摘要对特定成分的TWIP钢进行不同的退火处理，用金相、透射电镜对其拉伸变形前后的组织进行观察和分析。
- Annealing treatment of H62 brass with different Zn-content was carried on, and the hardness was tested, the microstructure was analyzed. 对不同锌含量的H62黄铜进行了退火处理,并进行了金相分析及力学性能测定。
- The Influence of Annealing Treatment on the Refractive Index Profiles of Ion-implanted Lithium Niobate Planar Waveguides[J]. 引用该论文 卢菲;孟鸣岐;李伟;王凤翔;王克明;邴永红.
- The annealing treatment can further decrease the resistively of all CdIn2O4 films, and the highest optical transmission was over 90% in the visible light region. 退火处理进一步降低了CdIn2O4膜的电阻率,在可见光区域内该膜的最高光透射率超过了90%25。
- The results obtainedfrom ESCA indicate that the CsI layer has high compatibility with the Au film before and after the annealing treatment inair for 0. 5h at 423K. 423K温度退火处理半小时前后,ESCA分析表明CsI层与Au膜具有高度的相容性。
- The methods to improve the intensity of cold-rolled sheets is to add some useful alloying elements during steel-making and improve the cooling rate annealing treatment. 提高冷轧薄板机械强度的方法主要是在炼钢时添加有益的合金元素及在热处理时提高退火后的冷却速率。
- The result indicates by using the confirmed te mperature to proceed annealing treatment,it can not only release welding residua l stress,but also do not cause the str... 结果表明,使用此方法确定的温度进行退火处理,既可使焊接残余应力充分松弛,又不会导致结构过度软化,有效保证了结构件的机加工性能和加工精度。
- Effect of Anneal Treatment on Microstructure and Property of Red Copper 退火处理对紫铜组织和性能的影响
- Anneal means make harden steel soft and remove brittleness. 退火就是使淬火钢变软并消除其脆性。
- He will not sit down under such treatment. 我不应再忍受好如此的礼遇。
- Compression properties of alloy after homogeneous annealing treatment ascend first and then descend with the increase of Sn content,the compression strength and limiting compressibility of alloy is greatest at about 1.0% and 1.5% Sn content,respectively. 均匀化退火后合金的室温压缩性能随Sn含量的增加先升后降;最大极限压缩率和压缩强度分别出现在1.;0%25Sn和1
- Their treatment of women is unspeakable. 他们对待妇女的方式恶劣得难以言表。
- His treatment of her was beyond endurance. 他这样对待她是无法忍受的。
- His treatment of his wife is outrageous. 他对待妻子十分蛮横。
- Annealing treatments cause the oxidation of Sm element and the formation of bcc-Fe nanocrystals. 热处理后,部分Sm被氧化且出现了bcc-Fe的晶粒。
- Nobody gets preferential treatment in this office! 本办事处无论对谁均一视同仁！
- Three. They are hardening, temper and anneal. 三种。它们是淬火、回火和退火。
- Three:they are hardening,temper and anneal. 三个过程：它们是淬火、回火和退火。
