您要查找的是不是:
- It is favorable for the increase of the adsorption film thickness by increasing the lyophobic chain.The determination of adsorption film thickness verifies the validity of the modification result. 木钠及改性木钠在疏水性和亲水性固体表面的吸附层厚度不同,其分子疏水链段的增加有利于增大其在疏水性(煤)表面的吸附厚度。
- Keywords lignosulphonate;adsorption film thickness;elliptical polarization;ESEM; 木质素磺酸钠;吸附膜厚度;椭圆偏振;环境扫描电镜;
- Determination of Adsorption Film Thickness of Lignosulphonate and Modified Lignosulfonate on Coal Surface as Coal-water Slurry Additives 木质素磺酸钠、改性木质素磺酸钠用作水煤浆添加剂在煤表面吸附膜厚度的测定
- adsorption film thickness 吸附膜厚度
- Nanospec Film Thickness Measurement System. 薄膜测厚仪,用于测量薄膜厚度。
- Dry film thickness measured on a smooth test panel. 干膜厚度应在平滑的样板上测量。
- The extent of EHD film thickness. EHD油膜的厚薄程度。
- One millionth of a meter. Used to express applied film thickness. 一个百万分之一米。用于表述涂层的厚度。
- Even slight contamination could affect film thickness to a considerable degree. 即使存在一点污染物就会对液膜厚度产生一定程度的影响。
- Glue film thickness adjusted automatically according to machine speed. 上浆厚薄可依车速自动调整。
- The process is to be optimized for promoting the film thickness uniformity. 通过选择合适的工艺、控制条件可以改善薄膜的厚薄均匀性。
- For intermediate paint in epoxy floor coating series on sealer or putty to increase film thickness and smoothness. 作为环氧地坪涂料系列的中间漆,涂于封闭底漆或腻子之上,用来增加漆膜厚度和涂层的平整性。
- The adsorption film became denser with the increasing of the dodecylamine concentration,so that the inhibition efficiency increased and also the adhesive forces measured by force curves were enhanced. 十二胺浓度越大,吸附膜越致密,缓蚀率越高,力曲线上测得的粘附力值也越大。
- The influence of paint coating number, mass fraction of diluent on film thickness and glossiness was studied. 研究了涂料涂装道数、稀释剂的质量分数对涂膜厚度和光泽度的影响。
- The desirable antifouling effect can be obtained when the film thickness meets the requirements. 漆膜厚度符合规定的要求时,可得到有效的防污效果。
- This shows that the impact ionizationeffect increasewith the decreasing of silicon film thickness. 这说明,随着硅膜厚度的减小,器件内部的碰撞离化效应增加。
- The combined effect of film thickness and stress on BTO ferroelectric behavior was studied. 实验结果表明,BTO薄膜中的应力为张应力。
- The film will breack down when the film thickness reaches to a critical value by film thinning. 当膜厚度变薄到一临界值时,膜破裂,导致破乳脱水。
- With the temperature increased, corrosion rate became higher due to increase of film thickness and condensation rate. 当湿气温度较高时,腐蚀速率随液膜厚度、冷凝速率和液膜温度的增加而增大。
- The hybrid cavity/surface plasmon mode is influenced by the film thickness and the periodicity of top Ag film. 混和的共振腔/表面电浆模态被二氧化矽膜厚与上表面金属的周期性所共同决定。