您要查找的是不是:
- adjusting main pressure 主油压调节
- Enter 0 for main pressure tolerance plus. 主压力正公差输入0。
- Activate the individual selection main pressure. 激活单个选择的主压力。
- Note the current main pressure actual value. 记录当前主压力的实际值。
- Adjust the tolerance limits of the main pressure in such a way that the pressure of the prepared punch lies within the tolerance limits. 调整主压力的允许范围,这时准备好的冲杆压力应在允许范围内。
- Enter 50% for main pressure tolerance plus and tolerance minus. 主压力正负公差输入为50%25
- Select "with filling" at the main pressure regulation. 选择“物料”调节主压力。
- Note the set value for compaction force main pressure. 记录主压力设定值。
- Direct connection to mains pressure water supply is not permitted. 严禁直接连在有压力的供水装置上。
- Thus it was demonstrated that the main pressure zone was little affected by the downstream flow condition. 由此可见,下游的流动情况对主要压力区几乎没有影响。
- The punch diagram displays that the increased compaction force main pressure will be regulated to the set value. 冲杆图表显示主压力增加校准设定值。
- Enter a value for main pressure set value that is approximately 10% higher than the displayed revolution average value. 输入一个主压力设定值,大约比旋转平均值高10%25。
- Enter a value for main pressure set value that is approximately 10% lower than the displayed revolution average value. 输入一个主压力设定值,大约比旋转平均值低10%25。
- The revolution average value displays that the compaction force main pressure exceeds the set value. 主压力旋转平均值超过设定值。
- The water pressure may need adjusting. 水压可能需要调整。
- Pay attention that the main pressure set value does not exceed the tolerance limit plus. 注意主压力设定值不能超过正公差。
- Pay attention that the main pressure set value does not fall below the tolerance limit plus. 注意主压力设定值不能低于正公差范围。
- Start the tablet press and keep it running until a new current revolution average value for main pressure is displayed. 启动压片机保持运行直到当前新的旋转主压力平均值被显示为止。
- A new value is entered at punch load that is below the value of compaction force main pressure. 在冲压加载主压力下输入一个新压力值。
- It makes the calculation analysis of the integral stability of the whole bridge in the process of tensioned main cable and adjustment main beam stress and the process of tensioned main cable taking the proposed reverse suspension bridge as the object. 以拟定的某反吊桥方案为对象 ,对张拉主缆索调整主梁应力过程及张拉主缆索过程中全桥的整体稳定性作了计算分析。