您要查找的是不是:
- Adhesively bonded bars are a new technique of bars anchorage.It has been widely used in rehabilitation, renovationand repairs of concrete structures, as it is easy toanchor steel to concrete. 植筋技术是一种新的钢筋锚固技术,在解决新老混凝土连接、钢筋漏埋错埋等钢筋生根问题中发挥着重要作用,被广泛应用于与结构加固改造中。
- In this paper,capacity of bonded bar has been deeply studied in theory and the mechanism and failure mode of adhesively bonded bars in concrete subjected to tension have been invesigated. 本文对植筋胶的锚固性能进行了深入的理论分析,研究了植筋在拉拔力作用下的破坏性态和破坏机理。
- Bond Behavior of Adhesively Bonded Bars in Concrete Under Static & Repeated Loads and Its Application 混凝土后锚钢筋的静动力粘结特性与工程应用 第十三届全国结构工程学术会议特邀报告
- adhesively bonded bars 后锚钢筋
- adhesively bonded bar 植筋
- The effect of the recessing on the strength and stress distribution of adhesively bonded single-lap joints is discussed. 研究单搭接接头胶缝中预留间隙对接头拉剪强度和应力分布的影响。
- Adhesively bonded Fiber Reinforced Polymers (FRP) on the surface of the damaged structures is an advanced repair method, which has been accepted by more and more engineers. 在结构损伤部位的表面粘贴纤维增强复合材料(FRP)进行加固修复是一种先进的结构修补方法,已被越来越多的工程人员所青睐。
- The fatigue life of the bonded plates is 2.06 times relative to that of the cracked one. The critical crack length of plate increases from 17.86mm to 28.64mm before and after adhesively bonded repair with composite patch. 裂纹板的临界裂纹长度从17.;86 mm增加到28
- Whether the adhesively bonded joints keep good vacuum tightness after experiencing repeatedly cooling and heating is an important factor that determines the durability of non-magnetic Dewar. 粘接接头在经历反复冷却、复温后能否保持良好的真空密封性,是决定无磁杜瓦耐用性的一个重要因素。
- Created numerical manifold model of fully bonded bar based on the limited cover technology of manifold method, this model is a new numerical model of bolt which use partially analytic displacement pattern. 基于有限覆盖技术,建立了全长粘结杆件的数值流形方法模型。
- adhesively bonded cleavage joint 劈裂接头
- adhesively bonded single lap joint 单搭接粘接接头
- Low alloy steel bonded bar stock assemblies 低合金钢粘合棒材料部件
- It showed that the strength of adhesive bonded structure would not decrease with a volume decrease of 20%. 拓扑优化的结果表明:在体积减少20%25的情况下,胶接结构的强度不会降低;
- The first requirement for any adhesive bond is that the adhesive most wet the substrate. 对所有粘结剂粘结的首先要求,就是必须能浸润基材。
- Reasons for quality problems of adhesive bond between cork sheets and composite cabin are analyzed. 分析了引起复合材料舱体软木粘贴质量问题的原因。
- Hum the opening bars of your favourite tune. 哼一哼你喜爱的曲子的开头几个小节。
- The small caged deer chafes against the bars. 关在笼子里的小鹿贴在栅栏上擦身体。
- The results show that the adhesion strength is low and the adhesion bonded aluminum sheet/polypropylene/aluminum sheet fractures at the interface when there is no MPP in PP. 研究结果表明: 当PP中不含MPP时, 界面粘接强度低, 拉伸剪切时表现为铝板/聚丙烯粘接界面的破坏;
- Suitable for perforating,compounding,and slicing,stretch fabric,pure cotton and adhesive bonded plaster,being able to do single-side as well as two-side perforating. 适用于弹力布、纯棉布、无纺布药膏的打孔、复合、切片,可单面打孔,也可以双面打孔。