您要查找的是不是:
- additional pressure drop 附加压降
- Watch pressure drop on pressure gauge. 手表压力在压力标准度量上降低。
- Valve exhibits high pressure drop. 阀门出现高压降。
- This will inevitably result in additional pressure on our margin. 这肯定会对集团的盈利造成压力。
- DID THE PRESSURE DROP TO 0 PSI AND A "NO DRIVE" CONDITION OCCUR? 压力是否降至0PSI而且条件"NO DRIVE"出现?
- However, the pressure drop occurs almost completely in the plug. 然而,压力降几乎完全发生在多孔塞中。
- Drier operates in either flow direction with low pressure drop. 在任何一方向都可操作应用。
- Presents the theoretical model of pressure drop for flexible duct. 摘要介绍了柔性风管压力损失的理论模型。
- Method informs the runtime of this additional pressure on system memory. 方法会将这一对系统内存的额外压力通知运行库。
- They are commonly used where a minimum pressure drop is important. 通常用在要求压降最小的应用场合。
- Method informs the runtime that the additional pressure has been released. 方法则通知运行库已释放额外压力。
- Read the pressure drop across the valve with a Watts Series PG meter. 利用美国瓦茨系列PG仪器读出通过阀门的压降。
- For compressible fluids, where pressure drop exceeds half the inlet pressure. 对于可压缩性流体,如果压降超过进口压力的一半。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 对于不可压缩性流体,如果压降产生空穴或闪蒸。
- The typical result is increased chemical mn-off to the landscape, and with ensuing degradation, additional pressure for expansion, and so on. 典型的结果是增加了流人到环境的化合物,跟着发生退化、膨胀的额外压力等现象。
- Back up roller: Roller which backs up the impression roller for additional pressure in gravure printing. 加压辘:在照相凹版印刷机上,给予压力圆筒额外压力的辊辘。
- The typical result is increased chemical mn-off to the landscape,and with ensuing degradation,additional pressure for expansion,and so on. 典型的结果是增加了流人到环境的化合物,跟着发生退化、膨胀的额外压力等现象。
- On the other hand,the SCEP latency was prolonged by 0.235 79 ms under 0.133 kPa additional pressure while the duration was constant. 压迫时间相同的情况下;压力每增加0.;133kPa;SCEP的潜伏期延长0
- Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm. 调整平衡阀直到压差表读出压降符合所要求的流量(加仑/分钟)为止。
- When a buried pipeline undergoes the different additional pressure,it will distort and become deformed due to the pressure difference. 当地下埋深管线两侧受到不同的附加压力时,由于压差的存在使管线发生了弯曲变形。