您要查找的是不是：
- The following example shows a Function procedure that defines two parameters. 下面的示例演示定义两个参数(parameter)的Function过程。
- Similarly, an overloaded binary operator would have one parameter when defined as a member and two parameters when defined as a nonmember function. 类似地，重载二元操作符定义为成员时有一个形参，定义为非成员函数时有两个形参。
- Finally, this algorithm is applied to some test problems and it has the better results than using the penalty function algorithm. 最后，本算法应用于几个典型例题，并与罚函数法相比较，数值结果表明该算法是可行的，有效的。
- Two parameters, no default values. 两个参数，没有缺省值。
- These two parameters are changeable. 这两个参数是可变的。
- In this paper, we try to apply Binary System Particle Swarm Optimization (BSPSO) with death Penalty function to solve 0/1 knapsack problem. 摘要将带有死亡罚函数的二进制粒子群优化算法应用于0/1背包问题。
- Assignment is binary, so the operator function has two parameters: The first parameter corresponds to the left-hand operand, and the second to the right-hand operand. 赋值是二元运算，所以该操作符函数有两个形参：第一个形参对应着左操作数，第二个形参对应右操作数。
- Penalty function method for solving constrained (minimum) optimization problem of a class of better algorithms. 罚函数方法是求解约束（极小）优化问题的一类较好的算法。
- Furthermore.The theory about penalty function method of bilevel multiobjective programming is established. 在单层化的基础上，建立了两层多目标规划的罚函数理论。
- Firstly, we can convert the constraint LMIP into unconstraint one by using the penalty function. 通过构造一种罚函数化有约束的LMIP为无约束或简单约束的LMIP。
- Unary operators have one parameter, and binary operators have two parameters. 一元运算符具有一个参数,二元运算符具有两个参数。
- In the Genetic Algorithm, penalty function is often used to deal with constrains. 摘要在遗传算法中，约束的处理一般采用罚函数法。
- Combined with exact non-differentiable penalty function, a new chaos genetic optimization algorithm is presented. 并结合精确不可微罚函数求解非线性约束优化问题，提出了求解此类问题的混沌遗传算法。
- The strategy used is to assume values for two parameters. 常用的作法是假设两个参数的数值。
- Provides two parameters to control aspects of best-fit mapping. 提供两个参数来控制最佳映射的各个方面。
- Lastly, PWL predictive control which uses the upper bound of optimal control as penalty function under certain conditions is proved to be stable. 最后证明了在一定条件下将最优控制的上限作为PWL系统预测控制的最终惩罚项可使预测控制算法保持稳定。
- This thesis analyses thecommon penalty function method and modified coulomb friction model used for contactanalysis in sheet metal forming simulation. 分析了常用的罚函数法接触算法和用于板料成形数值模拟的修正库仑摩擦模型。
- Through multiple generation calculation, the minimum point of penalty function value was obtained, then the optimalc reduction distribution was found. 通过粒子群多代运算，求出罚函数值最小点，得到压下负荷最佳分配点。
- In the elastoplastic fracture analysis for pipelines steel X60, J-A2 two parameter approach was adopted to predict the failure pressures of pipelines with surface cracks. 摘要在对X60管钢弹塑性断裂分析中，采用J-A2：双参数方法来预测带表面裂纹管道的破坏压力。
- By introducing penalty function terms,the problems,which would arise in the case of pure Lagrange multiplier method or penalty function method. 通过附加惩罚函数项，克服了单纯使用拉格朗日乘子法或惩罚函数法时存在的问题。
