您要查找的是不是：
- turbine inlet temperature control 涡轮进口温度控制
- Fan Turbine Inlet Temperature 涡扇进气温度
- Turbine Inlet Temperature 涡轮进口温度
- turbine inlet temperature (TIT) 涡轮进口温度
- This paper calculates the temperature of inlet air,and analyzes precedence of gas turbine inlet air-cooling by water spray evaporative cooling in Xinjiang area. 对进气空气的温度进行分析计算,并通过计算的结果分析在我国新疆地区燃气轮机采用喷雾蒸发冷却方式冷却进气空气的优越性。
- It is an adiabatic,humidification,and cooling process for gas turbine inlet air by water spray evaporative cooling. 对燃气轮机的进气采用喷雾蒸发冷却的方式降温是一个绝热加湿冷却过程。
- The structure and the aerodynamics performance of gas turbine inlet system is one of the important aspects when the gas turbine is installed on the naval vessels. 燃气轮机进气系统的结构和气动性能是燃气轮机装舰技术研究的一个重要组成部分。
- Check pressures and fluid inlet temperature be sure theyare within specified range. 检查流体压力和温度并取保他们在可用流体范围内。
- The sensible heat factors are found to increase with both Reynolds number and inlet temperature of cold water. 湿盘管的热传量随著入口风速与鳍片数目的增加而增加，显热比及除湿率亦随著风速增加而增大。
- The result can offer the proper inlet temperature and kinematical viscosity for spray drying. 结果：运动黏度对喷雾干燥的影响大于相对密度；
- Viscosity of pseudo-boehmite remains unchanged when inlet temperature is in certain range. 进口温度在一定范围时,产品黏度基本保持不变;
- The inlet temperature and internal temperature of exhaust catalyst for two-stroke moped are tested under different vehicle driving speed. 在不同车速行驶工况下对二行程轻便摩托车用尾气催化剂的入口及中心温度进行了测量与分析。
- Atmospheric conditions can change engine performance considerably. The effects of engine inlet temperature and ambient pressure on engine performance are shown in Fig[3.14]. 大气条件可以相当的改变引擎的性能。进气温度和环境压力对发动机性能的影响列于图[3.;14]。
- As for the dehumidifying conditions, the condensing rate for the humid air increases with Reynolds number but decreases as the inlet temperature of cold water increases. 同时湿盘管的热传量及除湿率亦也随著冰水入口温度的降低而增加，显热比随著冰水温度的降低而减小。
- The experimental results show that in the process of flow excursion the mass flow rate and the inlet temperature decreases,while the exit temperature increases smoothly. 研究结果表明：在发生静态流量漂移时，系统循环流量下降、加热段的进口温度下降而出口温度上升；
- Exhaust pressure at turbine inlet 涡轮入口废气压力
- Properly increasing the furnace inlet temperature, strengthening the process management and selection of aluminum diffused plates could effectively protect the corrosion. 适当提高尾气入口温度、加强工艺管理和采用渗铝板进行包补是防止腐蚀的有效措施。
- turbine inlet main steam pressure 机前主蒸汽压力
- Air systems are effective for space heating because a heat exchanger is not required and the collector inlet temperature is low throughout the day (approximately room temperature). 空气系统对于空间供热是有效的，因为热交换器是不必需的，且收集器的进口温度全天低（近似室内温度）。
- Inlet temperature, outlet temperature and drying air volume are displayed digitally. Condition setting dials and stage level control switch are located on the front panel for easy use. 入口、出口和干燥气流量数字显示,条件设定板、进程控制开关为方便使用被置于前板。
