您要查找的是不是：
- Supply Voltage Supervision 低电压监控
- Ohmic resistance measured between the supply voltage connections. 供电电路中测得的电阻(欧姆)。
- Features: Low VCE(sat),High performance at low supply voltage. 特点：饱和压降低,功率高和电压小。
- R1 charges up the negative side of C1 to the supply voltage, VDD. R1将C1的负向充电到供电电压VDD。
- This capacitance is discharged when the supply voltage is switched on. 为什么电源电压接通时电容是放电?
- This equates to reclosing with twice the supply voltage on the motor. 这等于再合闸电机上有两倍的电源电压。
- Two wires for the supply voltage and one for the receiver's R/C sum signal. 通常没有被引出，所以我们要打开接收机找到其中的那个焊点，将它引出。
- This paper presents a novel current source which is insensitive to supply voltage. 摘要这篇论文提出了一个和电源电压变动无关的新式电流源。
- Because the power supply rejection of most ADCs is fairly high, drifts in the power supply voltage do not adversely affect the measurement. 由于多数模数转换器的电源滤波是相当高,电源电压有害地偏差不影响这次测量。
- For mains-independent service in the field, the sensor can operate with a supply voltage of 6V. 传感器独立于主电源工作,可以在6伏的供电电压下运行。
- Power Supply Rejection: The ratio of the change in input offset voltage to change in power supply voltage producing it. 电源抑制比,输入失调电压变化量与引起该变化的电源电压变化量之比。
- The Voltage Selector Setting should be checked to see that it conforms to the local AC supply voltage. 必须查看本机交流电压选择器之预调状态是否符合本地交流电压。
- YOU MUST ENSURE THE BATTERY AND / OR POWER SUPPLY VOLTAGE DOES NOT EXCEED THE MAXIMUM SPECIFIED FOR YOUR SERVOS. 您必须保证电池和/ 或电源电压不超出最大值被指定为您的伺服机。
- The power supply voltage may be controlled by replacing D1, D2, R1 and R2 with a variable voltage reference. 将D1、D2、R1和R2换成一个可变参考电压源，本电路就变成了一个可控电源。
- The reference voltage, VREF, is applied externally and can be set up to the supply voltage, VDD. 基准电压（VREF）由外部提供，最高可以设置为电源电压VDD。
- Voltage generated by the motor at the instant of reclose may be equal to the supply voltage but exactly out of phase. 再合闸瞬间电机产生的电压可与电源电压相等但正好失相。
- However if the supply voltage or ambient temperature is low the machine still reduces input power at this preset time. 然而如果电压或环境温度低，机器仍要在这时减少能量输入，就会导致烘焙时间长和“烤豆”。
- Supply voltage (effective value, frequency and waveform) for which the technical specifications of the force transducer apply. 力传感器所使用的技术说明中所规定的供电电压(有效值、频率、波形)
- The required supply voltage shall be within the scope of changes to meet the standards in section 5.3 Of the basic functional requirements. 在规定电源电压变化范围内均应满足本标准第5.;3条的基本功能要求。
- The generator may be made independent of temperature and supply voltage if the detector is clamped with matched zener diodes as shown in Figure 28. 只要按图28那样在阈值检测器中使用性能匹配的稳压二极管,那么这个信号发生器电路就可以做到与温度变化和电源电压变化无关。
