您要查找的是不是:
- Size - the output buffer size 输出缓冲大小
- The string to write to the output buffer. 写入输出缓冲区的字符串。
- When overridden in a derived class, flushes the output buffer. 在派生类中被重写时,刷新输出缓冲区。
- Method flushes any messages currently in the output buffer to the log file. 方法将当前位于输出缓冲区中的所有消息刷新到日志文件。
- The application tried to transmit a character, but the output buffer was full. 应用程序尝试传输一个字符,但是输出缓冲区已满。
- Copy the specified minimum number of characters to the output buffer. 复制指定的最少数目的字符到输出缓冲区。
- For numbers, copy the specified minimum number of digits to the output buffer. 对于数字,复制规定最小数目的数字到输出缓冲区。
- Object is used to access the output buffer for sending content directly to the output stream. 对象访问输出缓存以直接向输出流发送内容。
- You can specify whether to automatically flush the output buffer after each write by setting the. 指定在每次写入之后是否自动刷新输出缓冲区。
- Specifies whether the trace listeners automatically flush the output buffer after every write operation. 指定跟踪侦听器是否在每次写入操作后自动刷新输出缓冲区。
- Allows you to write to the output buffer mechanism in the same way as print() and echo(). 允许向输出缓冲机制写入数据,和print()与echo()的方式相同。
- The page buffer size used by the Java VM. Java VM使用的页面缓冲区大小。
- The up-mixer with the output buffer achieves an IIP3 of 8 dBm and an input P1dB gain compression point of 0 dBm. 从上混频电路输出级测得IIP3约8 dBm,IP1dB压缩点约为0 dBm。
- The internal stream buffer size. 内部流缓冲区大小。
- A new file with the specified buffer size. 具有指定缓冲区大小的新文件。
- If the given stream was open for writing and the last i/o operation was an output operation, any unwritten data in the output buffer is written to the file. 如果是输出,上一个操做是写入,那么将会把未写入的缓冲内容写入文件。
- To transmit data through the bi-direction bus, the program first tests the /OBF signal to determine whether the output buffer is empty. 通过双向总线传输数据时,程序必须先测试*OBF信号,来决定输出缓存是否为空。
- In a read mode, the selected selecting circuit will send the stored information through to the output buffer for output from the integrated circuit. 在读出模式中,为从该集成电路中读取,所选的选择电路将发送所储存的信息到输出缓冲器。
- As soon as the output circuitry sees a logic 0 on /OBF, it sends back the /ACK signal to remove it from the output buffer. 一旦外部电路检测到*OBF变为0,它就送回*ACK信号并把数据从输出缓存上拿走。
- Writes data to the serial port output buffer. 将数据写入串行端口输出缓冲区。