您要查找的是不是：
- Remove cover bolts and cover. 拆卸阀盖螺栓和阀盖。
- Loosen cover bolts and remove cover. 松开盖螺栓，拆卸阀盖。
- Remove the bolts and cover, realign the diaphragm assembly, and place the cover back on the relief valve body. 拆卸螺栓和阀盖，重新校准隔膜总成，并将阀盖放回到安全阀阀体上。
- Remove the relief valve cover bolts while holding the cover down. 拆卸安全阀阀盖螺栓,握住阀盖并将其取下来。
- Loosen oil pan bolts and remove the front bolt at each side. 松动油底壳螺栓，拆下每一面的前螺栓。
- Remove vibration damper bolt and washer from end of crankshaft. 从曲轴端拆下减震器螺栓和垫圈。
- These bolts and nuts hold the wheels on. 这些螺栓和螺帽把轮子固定下为。
- Remove covers and remove Disc Assembly. 拆卸盖子，并拆卸阀瓣总成。
- Remove the bolts and lift the pan off the manifolDiscard the gasket. 拆下螺栓并举高盘脱离歧管。扔掉衬垫。
- Replace body bolts and torque evenly to70 ft./ lbs. 重新放置阀体螺栓，并且用70英尺/的扭矩均匀的旋紧。
- Add also the radish and cover with lid. 可同时放入日本萝卜，并盖上锅盖。
- Fasteners. Clearance hole for bolts and screws. 紧固件。螺栓和螺钉的自由尺寸孔。
- Kit includes: Seat, Retainer Wire and Cover O-ring. 组件包括：阀座，固定器线圈和阀盖O形环。
- Replace body bolts and torque evenly to 70 ft./lbs. 重新放置阀体螺栓，并且用70英尺/磅的扭矩均匀的旋紧。
- Bolts and nuts are plated for corrosion resistance. 螺栓和螺母经过电镀防腐蚀处理。
- Send us a resume and cover letter. 将简历装入信封发送给我们。
- Unique relief valve cover nut design eliminates use of cover bolts and simplifies alignment 独特的安全阀阀盖螺母结构,避免采用阀盖螺栓和简化对齐工序
- The bolt and handle are deadlocked against turning. 门闩和把手全卡住了，转动不了。
- Turn the cake upside down and cover it with cream. 把蛋糕翻过来抹上奶油。
- Disinfect and cover all wounds properly. 如有伤口,须妥善消毒和包扎。
