您要查找的是不是：
- Discussion on the Effecting Factors on the Outlet Gas Temperature of Flash Smelting Furnace Waste Heat Boiler 影响闪速余热锅炉出口烟气温度因素的探讨
- Determination of Outlet Gas Temperature of Hydrogen Chloride Synthesis Converter Made of Graphite 石墨制氯化氢合成炉气体出口温度的确定
- Outlet Gas Temperature 出口气体温度
- It relied on exhaust gas temperature (EGT). 就靠排气的温度，看到的都是单线和双线的氧传感器。
- Use several kinds of thermal calculation methods of boiler's furnace,and calculate the outlet flue gas temperature of a low load of some supercharged boiler. 运用几种热力计算方法,对某型船用增压锅炉低负荷工况的炉膛出口烟气温度进行了计算。
- Discussing the cause of flue gas temperature difference at furnace outlet in 4 corners tangentially coal fired boilers and proposing measures to eliminate such difference. 讨论了四角切圆燃烧锅炉炉膛出口烟温偏差的原因,提出了消除偏差措施的设想。
- The computer programme worked out this way has been applied in the measurement of gas temperature at the outlet of a certain high heat-tolerance combustor, obtaining the outlet temperature field. 根据此方法编制的计算机程序已应用于某高热容燃烧室出口燃气温度测量中，获得了燃烧室出口温度场。
- The major factors is excess air and flue gas temperature. 影响注汽锅炉运行热效率的主要因素是排烟温度和空气系数,测算分析表明,大部分注汽锅炉二者均超标。
- Based on thermal dynamic theory,this article presents the calculation procedure for outlet flue gas temperature and vaporized water quantity of absorber for limestone-gypsum wet FGD. 根据热力学基本原理,提出了石灰石石膏湿法烟气脱硫吸收塔出口烟气温度及蒸发水量的计算过程。
- The relationship between isoflurane part ial pressures in arterial blood and in oxygenator outlet gas during cardiopu lmonary bypass. 体外循环中异氟醚动脉血中分压与氧合器出口气中分压的关系
- LV Technology has developed this time the new concept cyclone, called LVC, which is used for down stream of mill outlet gas with smaller pressure loss and higher collection efficiency. 至今，lv技术已开发出称为lvC的新型概念旋风筒，它用于磨机出口，以较小的压降获得较高的收集效果。
- However, for certain temperaturesensitive materials the inlet gas temperature must be lowered. 但是，对于某些温度敏感的材料，进入的气体温度必须降低。
- However, for certain temperature sensitive materials the inlet gas temperature must be lowered. 但是,对于某些温度敏感的材料,进入的气体温度必须降低。
- This paper ensures the math model of gas temperature of cement decomposing furnace exit by analyzing its character. 摘要通过对水泥分解炉的特性进行分析，确定了出口气体温度的数学模型。
- The network was compared with recurrent neural network (RNN) by predicting exhaust gas temperature (EGT). 分别利用递归神经网络和双隐层过程神经网络对发动机排气温度裕度进行仿真预测。
- The influent of the exhaust gas temperature and inlet air temperature to PGT10 gas turbine is presented. 介绍了出口乏气温度、入口空气温度对PGT10燃气透平的影响;
- The waste gas temperature and convulsion negativepressure are main craft parameter agglutinates of the end-point. 废气温度和抽风负压是烧结终点控制的主要工艺参数。
- Thereby, the efficiency would enhance while the flue gas temperature in back-end ductwork is appropriately chosen. 较低的尾部烟气温度有利于提高SO2溶解度，从而提高灰浆脱硫的能力。
- The magnitude of the turbulence then follows directly from the observed line with if the nebular gas temperature is known. 如果已知星云气体的温度，则湍流的大小可直接从观测的谱线宽度得出。
- The rising position of gas temperature was stabled by adjusting pallet speed, and the short-term control was carried out. 短期控制通过调整机速，稳定废气温度上升点实现。
