您要查找的是不是：
- Keywords preparation method;superfine aerogel;Ni based catalyst;physico chemical property;methane;carbon dioxide;reforming; 制备方法;气凝胶超细粒子;镍基催化剂;物化性质;甲烷;二氧化碳;重整反应;
- Study on the Supported Nanosized Zro_2/Al_2O_3 Composite Supports and Ni Based Catalysts 负载型纳米ZrO_2/Al_2O_3复合载体及Ni基催化剂的研究
- Carbon nanofiber (CNF) is a novel carbon based catalyst support. 纳米碳纤维（CNF）是一种新型的碳基催化剂载体。
- The effect of inverted two-stage aging on microstructure and properties of a Ni base superalloy has been studied. 研究了固溶+两段时效热处理工艺对镍基高温合金组织及性能的影响。
- Study on the precursor phase composition of iron catalyst and discovery of FeO based catalyst for ammonia synthesis. 铁催化剂母体相组成的研究和FeO基合成催化剂的发现。
- The wear-resistant dispersion-eleetroplated layer is composed of high-hardness particles distributed on a Ni base. 耐磨分散电镀可以赋予零件表面以镍基体上分布着高硬度微粒的镀层,从而有效地提高耐磨性。
- The reaction mechanism of NBC-1 non_chromium iron based catalyst is studied through TPD,TPSR and PSR. 通过TPD、TPSR、PSR等手段 ,对NBC -1型铁系无铬CO高温变换催化剂进行了变换反应机理的研究。
- A Ni base superalloy columnar preform were produced through nitrogen spray atomization and deposition. 利用氮气雾化喷射沉积技术成功地获得了宇航用变形镍基高温合金柱形坯。
- A kind of CrF 3 based catalyst for HHFC 134a preparation by reacting HFC 133a with AHF via vapor phase fluorination is reported. 报道了一种由HCFC 133a与AHF经气相催化氟化制备HFC 134a的CrF3 基催化剂。
- The dendritic morphologies of a Ni base single crystal superalloy in , and orientations were observed by optic microscope. 用光学显微镜观察了沿 [0 0 1],[0 11]和 [111]方向生长的镍基单晶高温合金的枝晶形态。
- The process of acetic acid production by direct oxidation of ethylene was studied using Pd-SiW 12 /SiO 2 based catalyst. 采用Pd-SiW12 /SiO2 系列催化剂 ,对乙烯直接氧化制乙酸工艺进行了研究。
- The wear test of Ni based alloy-Cr/WC composite coating without lubrication is carried on a MM-200 pin-on disc wear tester and study wear-resisting property. 在MM-200型销盘式磨擦磨损实验机上,对Ni基Cr/WC复合涂层进行了无润滑的干磨擦磨损试验,研究其磨损特性。
- Cu-Co based catalyst for higher alcohol synthesis from CO 2 and H 2 were prepared using coprecipitatioin and characterized through XRD,TPR. 利用共沉淀法制备二氧化碳加氢合成低碳醇的 Cu- Co基催化剂 ,采用 XRD和 TPR等方法对 Cu- Co基催化剂进行物理表征 ,考察制备催化剂时不同加料顺序对其物性的影响 ;
- Therma fatigue behaviors of Ni base alloy chromium carbide composite coating made by a vacuum fusion sintering method are discussed in this paper. 研究了用真空熔烧法制得的镍基合金-碳化铬复合涂层的热疲劳行为。
- Etherification of propylene oxide with methanol using MAF solid base catalyst had been investigated. 研究了甲醇与环氧丙烷在固体碱催化剂MAF存在下非均相合成丙二醇甲醚的过程。
- The multilayered composite of Ni Zn ferrite composite paint, PZT paint, tetrapod like Zinc Oxide whisker paint with Ni based paint have been studied in this paper. 涂层结构及厚度直接影响所制备涂料的屏蔽效能。
- Surface grain refinement of turbine blades in Ni based superalloy K18 were studied by comparison of experimental results in different alloys and mold surface materials. 选用K18合金和纯金属镍及不同的面层细化料,通过实验对比研究了镍基高温合金叶片表面晶粒细化机理。
- Optics Microscope, scanning electron microscope( SEM) and X- ray diffraction( XRD) methods were used to investigate the structure of synthesized iron- based catalyst. 本文利用光学显微镜、扫描电镜和X射线衍射仪研究了金刚石合成后的铁基触媒组织结构。
- Irone was obtained through three steps reactions with citral and acetone.Citral reacted with acetone in the base catalyst to give pseudoionone. 采用山苍子油提取得到的柠檬醛和丙酮等为主要原料合成鸢尾酮。
- Typical application: Co-WC powder, chrome oxide powder, Lead sesquioxide powder, Chromium carbide powder, zirconium oxide powder, Ni Base Alloy-Chromium Carbide,etc. 典型应用：钴碳化钨粉、氧化铬粉、三氧化二铅粉、碳化铬粉、氧化锆粉、镍铬碳化铬粉、钴铬铌钇粉等。
