您要查找的是不是:
- Molded Base Line 模型基线
- Mold base to be minimum hardness of 165 BHN. 模座的最低硬度为165布氏硬度。
- Mold base can be of mild steel or aluminum. 模座可以用一般的钢材或者铝。
- Mold base to be minimum hardness of 280 BHN. 模座硬度最小为280布氏硬度。
- They each judge one side line and one base line. 他们四人各自裁判一条边线或一条端线。
- It will be a base line for future bird studies all over the world. 这将是未来全世界研究鸟类的一个基准。
- The base line can be set out as a single or double chain. 基线可作为一条单链系或双链系。
- The mold cavity was obtained by splitting mold base in parting surface. 模具型腔可采用分型面分割模板的方法获取。
- First, set a base line: determine how you do at present. 首先,设定最基本的指标,确定你现在所做的程度。
- The base line of this triangle is 20 centimeters long. 这个三角形,底边的长度是20厘米。
- They judge the side lines and the base lines. 他们判断边线和底线球(界内或界外)
- The escapement vector is parallel to the base line of a row of text. 行距向量与文本行的基线平行。
- What are the side lines and the base lines. 什么是边线和底线?
- It is the distance between the base line and the ascender line or cap line. 是从基线到大写顶线或上升笔划线的距离。
- It would be different if all contenders started at the same base line. 如果所有的竞争者都是在同一起跑线上,这可能反倒不寻常了。
- It showed Coetzee's deep humanism by found the people's base line of spirit. 对人在困境中的精神底线的发现和揭示,显示了库切深刻的人道主义关怀。
- Professionally design plastic mold: 3Dsplit mold and core, split assembly parts, design whole mold base, as concept layout, cooling layout, eject pin layout, etc. 3D分模分拆模仁, 分拆组装零件,模胚完整设计,如结构策划,运水设计,顶针设计等。
- Investigation and description of the status of the existing environmental setting and base line. 环境现状调查与描述。
- This paper also introduces a new mold base design method, which applies technique of Case-based Reasoning, and presents the structure and manager of Case Base of mold die of press die. 本论文运用基于事例推理技术(CBR),对冲裁模设计中的模具结构设计进行了研究,提出了模具结构的CBR设计方法,并以此为基础提出了冲裁模结构事例库的结构和管理方案。
- Descender: The part of an English character which falls below the base line, as in j ,g, p ,q,and y. 下降笔划:英文字母的笔划,在基线以下的部份。如J,G,P,q和Y。