您要查找的是不是：
- MEMS Sensor for Fuze System 引信用微机电传感器
- Breuer, K., “MEMS Sensors for Aerodynamic Application the Good, the Bad,” 38th Aerospace Sciences Meeting &Exhibit, AIAA paper No. 2000-0251, January 10-13, Reno, Nevada, (2000). 杜荣国;“MEMS热膜感测器设计制造及应用于探讨非定常流动分离现象”;国立成功大学航空太空工程研究所硕士论文;(2003).
- Adaping multi sensor fuze system is an effectual approach to acquire more information of target enhance anti jamming and reliability of fuze and improve fuze warhead coordination. 采用多传感器的引信系统是获取更多的目标信息 ,提高引信抗干扰性、可靠性、改善引战配合的有效途径之一。
- Temperature sensor for rechargeable batteries. 可允电电池的温度探测。
- Study on MEMS Sensor and Applications of Fuze MEMS传感器及在引信中的应用研究
- A humidity automatic control system with a hygrometer as the sensor for spectral instrument room was studied. 摘要研究了用湿度计作传感器的湿度自动控制系统。
- To design and optimize a 3D micro electro-mechahical system(MEMS) micro tactile sensor for dimension measurement of micro structure, a mechanical module of sensor under transverse load is presented. 提出了一种用于微结构几何量测量的MEMS三维微触觉式传感器在横向负载下的力学模型;用于指导传感器的设计和优化.
- Numerical simulation is an effective method to evaluate the laser fuze system. 考核激光引信系统性能的有效方法是回波信号的数字仿真。
- Check temperature sensor for open or shorted circuit. 检查温度感应器是否断路或短路。
- The principle of the optical fiber MEMS sensor, which is based on Fabry-Perot interference, is discussed. 建立了光纤MEMS压力传感器的光学理论模型，从理论上探讨了基于光波长调制测量压力的原理。
- The fracturing process of the granitic sample was monitored in near-source using MEMS sensor and the suited technology. 摘要使用MEMS传感器及其配套技术，近源监测花岗岩样品的受压破裂过程。
- The BDC height is measured by liner sensor for automatic offset. 线性传感器测量下死高度，并自动进行修正。
- The analysis results obtained have shown that the performance of the intelligent air burst fuze system is very good. 分析计算结果表明智能空炸引信提高了引爆概率。
- In this paper, the information integrated system for fuze design, with four layers structures, is studied and presented. 提出并分析引信设计库及相关信息资源集成系统的四层结构模型:支撑层、网络层、系统集成层和工作应用层。
- To reduce the production costs and simultaneously obtain high production quality, a flexible microassembly system for automated anodic bonding of MEMS sensors is developed. 为了降低生产成本，同时提高传感器的产品质量，研制了柔性自动阳极键合系统。
- The thesis mainly researches on inductive displacement sensor for AMB. 本文研究了用于磁悬浮轴承系统的电感式位移传感器。
- In this paper, the method that how to design electronic time fuze system by use of MPU technique and EEPROM technique is mainly researched. 本论文主要研究了利用微处理器技术、串行EEPROM存储器技术等设计电子时间引信系统的方案。
- A Novel Fiber Grating Sensor for Simultaneous Measurement of Strain and Temperature Based on Prestrain Technique[J]. 引用该论文 张颖;关柏鸥;董新永;刘志国;郭转运;开桂云;董孝义;苏万华.
- Batch microassembly of MEMS sensors is limited by the manual manipulation required specially trained technicians. 摘要手工操作限制了MEMS传感器的批量生产。
- Switch，Jacks,Encoders,Potentiometers，Sensor，For Small Memory Card,Connectors,Relays,Solenoids! 开关，插座，按键，编码器，可变电阻器（电位器），传感器，继电器，连接器，多功能操作装置。
