您要查找的是不是：
- For the two stages brass tube with high aspect ratio, there are many challenges in the front of tool makers. 本文深引伸模具开发所应用的技术范围为多道次深引伸传送冲模技术。
- The preparation of wollastonite of high aspect ratio is an important matter of further procession of wollastonite ore. 高长径比超细硅灰石的制备是硅灰石矿物深加工技术的一个重要研究内容。
- Carbon fiber having the character of high aspect ratio and low density reaches to the vadose zone in lower content. 研究结果表明：钢纤维长径比小，密度大，和粒子状的碳黑一样，在很高掺量仍处于未渗流区，两种水泥石的力电耦合效应都不明显。
- CNTs has a high aspect ratio, low work function, good electrical conductivity and nanometer tip, which can emit electrons at low voltage. 尤其是它具有大的长径比，低的功函数，良好的导电性和纳米级的尖端，使其能够在相对较低的电压下就能长时间地发射电子，因此被认为是一种优良的场致发射阴极。
- By use of this technique, we fabricated scaffold-like micro-well structures with sub-micron resolution and high aspect ratio by both raster scanning and pinpoint scanning methods. 与其它微加工技术比较，使用此方法除可制作复杂的三维微结构外，同时它又具有免用光罩、制作步骤简单、真正三维的立体结构及高解析度之优点。
- Hot embossing technology is used to manufacture high precision, high quality, and high aspect ratio of polymer micro structures. 热压成形技术可用以制造高精度、高品质、高深宽比之塑胶微结构。
- In this paper, the author would like to disclose the development in transfer tool for high aspect ratio deep drawing brass tube with two stages at MIRDC. 摘要本文主要介绍金属工业研究发展中心，以深引伸传送技术开发高长径比双阶差黄铜管件深引伸模具之成果，包含工程规划、模具设计及试模等方面。
- In this paper, a semi-empirical prediction method of maximum lift coefficient at low subsonic speeds for wings/bodies with high aspect ratio is investigated. 本文研究了大展弦比机翼／机身低亚声速最大升力系数的半经验预测方法。
- J. A. Chang, S. C. Chen and J. C. Cin, 2006, “Rapid Mold Temperature Control on Micro Injection Molded Parts with High Aspect Ratio Micro Features”, ANTEC, pp.1275-1279. 李育云，2002，“感应加热应用于模具快速加热之研究”，中原大学，机械工程技术研究所，硕士论文。
- At last, the preparation of wollastonite powders was reviewed.It was pointed out that nano-wollastonite and wollastonite of high aspect ratio were the near future developing tren... 最后,介绍了硅灰石粉体制备的现状,认为硅灰石纳米化、获得高长径比是今后的发展方向。
- Most notably, a permanent hollow hole with a high aspect ratio will be produced on the copper substrate, while copper atoms in close proximity to the hole are only slightly disordered. 利用较短的单壁奈米碳管对铜基板进行深孔加工后，会在铜基板上产生明显的中空孔洞，而孔洞周围的结构只受到非常轻微的影响。
- The kinetics of the electrode reaction is preliminarily studied by linear potential sweep technique and electrochemical impedance while electrodepositing Ni for high aspect ratio structures. 采用线性电位扫描和电化学交流阻抗等电化学测量技术,对高深宽比掩膜条件下微电铸镍的电极反应动力学过程进行了初步研究。
- HDP have better gap fill capability than the typical PECVD technology to meet smaller features with higher aspect ratio requirement. 为了满足深亚微米集成电路工艺对成膜特性的要求，开发出了高密度等离子体化学气相淀积薄膜（HDP） 技术。
- Dry etching for high aspect ratio microstructures 深高宽比微结构的干法刻蚀
- Plating High Aspect Ratio Blind Vias 高厚径比盲孔电镀
- Micro-hole with high aspect ratio 微深孔
- Compared with conventional aqueous HF-based electrolytes, the titania nanotubes prepared from nonaqueous organic electrolytes exhibit higher aspect ratio and higher photoconversion efficiency. 与传统的水溶性电解液相比，其深宽比和光电转换效率有了很大的提高。
- Shock Wave Aided EDM of the High Aspect Ratio Micro-Structures 激波压力扰动辅助电火花加工高深宽比微细结构方法研究
- High Aspect Ratio Microleverages Based on Silicon-on-Insulator Wafer 基于硅隔离衬底的高深宽比微型杠杆机构研究
- Filling High-Density High Aspect Ratio Vias and High-Volume Production Setting 充填高密度高厚径比导通孔和大量生产装置
