您要查找的是不是：
- Gas pressure loading method 有限元法
- Based on the experiment, we describe the multilevel pipe pressure loading method that can simulate the high back pressure of pump and has low noise property. 摘要在试验研究的基础上，论述了多级节流增压模拟水泵实际运行背压的低噪声特性。
- They measure gas pressure five times per hour. 他们每小时测量五次气压。
- Gas pressure due to the materials inside the star. 第一种向外压力是恒星物质所造成的。
- Gas pressure gauge and fill valve. 气体压力表及充气阀。
- The gas pressure is adjusted so as to balance the beam. 通过调整气体的压力可以使天平横梁平衡。
- Load method loads but does not show the form. 方法可加载窗体但不进行显示。
- Then the gas pressure builds up until the volcano erupts. 这样，气体压力就会越来越大，以致引起火山爆发。
- WOG=water,oil,gas pressure, WSP=working stream pressure. 600WOG表示英制球阀，150WSP表示压力，具体参数不明！
- Specifies the open report method for the ReportDocument Load method. Load方法的打开报表方法。
- And therefore the return value of the Load method cannot be marshaled. 所以当此方法尝试将所加载程序集的。
- Under the detonation gas loading, the cracks near the hole extend under the gas-driven and the father cracks grow under the gas pressure and the in site stress. 在爆生气体作用下，爆破近区的裂纹在气体驱动压力下扩展，而爆破中区的裂纹扩展是在气体膨胀压力场和原岩应力共同作用下发生的。
- Specification for Reinforced Epoxy Resin Gas Pressure Pipe and Fittings (08. 增塑的环氧树脂气压管和配件规范(08。
- AUTOMATIC KNIFE INPUT DEVICE; GAS PRESSURE CONTROL, EASY TO BE OPERATED. 自动进刀装置，采气压控制，方便操作。
- And pH gradient active drug loading method was employed to improve the DEE of INT liposome. 通过pH梯度主动载药法提高脂质体的包封率;
- It might entail soap testing to make leaks visible when gas pressure is used. 当使用气压试漏时，可以使用肥皂水来目测是否有泄露。
- The ARV wall may have thickened due to systemic pressure load, resulting in reduction of wall motion of the ARV on transthoracic echocardiogram. 由于主动脉压力负荷增加使右室壁变厚，经胸超声心动图显示出右心室壁位移.
- In the dry tube switching for gas exports dry gas pressure stability. 在干燥筒切换时连续供气，出口干燥气工作压力稳定。
- Controls how the values from the data source will be applied to existing rows when using the Load or Load method. 当使用Load或Load方法时控制数据源中的值如何应用至现有行。
- Adjusting delay time and gas pressure can reduce the warpage of the part. 工艺上可以通过调整延迟时间和气体压力来减小产品的变形量。
