您要查找的是不是：
- Reliability range of steel thin-wall internal pressure vessel fuzzy static strength during pressure test 压力试验时钢制薄壁内压容器模糊静强度的可靠度
- Minimum Reliability of the Fuzzy Static Strength of the Thin-Wall Internal Pressure Cylinders 薄壁内压圆筒模糊静强度的最小可靠度
- Fuzzy Static Strength 模糊静强度
- On the basis denoted above, calibrating calculation is conducted on its stiffness, static strength, fatigue strength and its stability. 在此基础上,对支架进行了刚度、静强度、疲劳强度和稳定性校核计算。
- Study on the influence of constitutive parameters of rubber on static strength of the resilient wheelset is also carried out. 同时，研究了橡胶的本构参数对弹性轮对静强度的影响。
- The hinge sleeve is the key part of the diamond cubic press, now its design bases on the static strength and the analogizing design. 摘要金刚石六面顶压机的关键零件铰链梁工作中受变载荷作用，易出现疲劳破坏。
- Utilizing the finite element method, the dynamic strength and static strength of transformer HV winding under short-circuit force are calculated. 对短路电动力作用下的变压器高压绕组，应用有限单元法分别进行了动态强度计算和静态强度计算。
- The static strength test results and carbody steel structures of 25G semi cushioned seat cars and semi cushioned berth sleeping cars are described briefly. 简述了南京浦镇车辆厂生产的25G型硬座车和硬卧车的车体钢结构及其静强度试验结果。
- By using this method, it is quantitative analyzed that reliability range of virgin static strength of spherical vessel at pressure test of all severe condit... 在最苛刻的气压与液压试验条件下,对球形容器初始静强度的可靠度范围进行定量分析。
- The aim of induction quenching has been enlarged from only improving local wear resistance to improving whole static strength and fatigue strength of parts. 感应淬火的目的已从仅仅提高零件的局部耐磨性扩大到提高零件的整体静强度和疲劳强度。
- Finite element analysis of structural static strength under the highest excavating load is carried out and the dangerous structural strength positions on the boom are obtained. 在结构静强度分析的基础上，对液压挖掘机动臂上关键部位板件的厚度进行了基于静强度响应的灵敏度分析。
- The effects of laminate static strength, fiber static strength and loading ratio to S-N curve were analyzed and all parameters could be gotten conveniently in the model. 此模型同时考虑复合材料受载方向的静抗拉强度、纤维静强度、疲劳载荷应力比等诸多因素对S-N曲线的影响，且模型中所用参数容易得到。
- The results showed that the statistical characteristic for static strength and residual fatigue strength of carbon epoxy laminates could be properly described by this distribution model. 结果表明,这一分布模型能够更全面地描述复合材料层板静态强度和疲劳剩余强度的统计特性。
- The allowable strength, static strength, fatigue life and load-carrying capability of hydro-bulged rear axle housing in a 0.75 t truck are analyzed using FEA software ANSYS and the variation rule of its strength is obtained. 摘要以0.;75t货车液压胀形桥壳为例，利用有限元分析软件ANSYS对其许用强度、静强度、疲劳强度（寿命）及其承载能力进行分析，得到液压胀形桥壳强度的变化规律。
- Results showed that the fatigue behavior of the YW-1 adhesive beared a resemblance to that of the metal material and the fatigue limit value of the copper oxide-phosphate inorganic adhesive was equal to 41 25% of the static strength value. 结果表明 :磷酸氧化铜无机胶的抗拉疲劳特性与金属材料的特性较相似 ,该无机胶的抗拉疲劳极限为其静拉伸剪切强度的 41 2 5%25。
- The results of the test show that the static strength of this frame fulfills the requirement of TB/T1335-1996,and the fatigue strength of this frame fulfills the requirement of AAR-M213-80. 试验结果表明 ,构架的静强度满足TB/T13 3 5 -1996规定的标准 ,疲劳强度满足AAR -M2 13 -80规定的要求
- The features of Frame of Truck Used for Freight Car Exporting to Pakistan is introduced. According to the standards of TB/T1335-1996 or AAR-M213-80,the static strength and fatigue test of this frame is completed. 介绍了出口巴基斯坦货车转向架构架的结构特点 ,分别按TB/T13 3 5 -1996规范和AAR -M2 13 -81技术条件对其进行了静强度和疲劳强度试验。
- The trialproduction and test indicate that the static strength and dynamic fatigue strength meet the design requirements,and that the noise in the driver's cab is not conformed with the standard at high speed. 试制试验表明,动力车车体静强度和动疲劳强度满足设计要求; 司机室噪声在高速时超标。
- The restraints to the model include mass of the structure, static strengths, static stiffness and dynamic displacement response amplitudes. 以塔机结构系统质量、静强度、静刚度、动态位移响应幅值等为约束条件。
- A soft or fuzzy surface on fabric or leather. 绒毛织物或皮革上的柔软或绒毛状的表面
