您要查找的是不是：
- Dynamic Test Fixture 动态试验设备
- To design, fabricate and repair test fixture. 设计;制作和修理测试机架.
- To plan and control the assumption of test fixture materials. 计划和控制测试机架原材料。
- Chengdu Chengbang Dynamic Test Apparatus Co., Ltd. 成都诚邦动力测试仪器有限公司。
- Static and dynamic test methods for port cranes me. 港口起重机金属结构静载及动载试验方法。
- Rescue boat davit (life raft davit) to be done dynamic test. 救助艇架(救生筏吊架)动负荷试验。
- The requirement for a good test fixture is maximum stiffness for the lightest possible weight. 一台好的试验固紧装置应该是重量轻而刚度大。
- Have rich experience on test fixture building, able to build pneumatic controlled fixture is prefer. 具有丰富的测试治具制作经验,懂气动控制治具制作优先。
- To prevent transients, always turn the source off while switching contacts in and out of the test fixture. 为了避免发生瞬变现象，一定要先将电流源关闭，然后再把接点接入测试夹具或将其断开。
- How static and dynamic testing differ? 静态测试和动态测试有何不同?
- DUT is placed in test fixture such a diode, transistors, microstrip circuit and so on. 被测件放在测试夹具里，如二极管、晶体管、微带电路等。
- Use both static and dynamic testing. 静态测试和动态测试相结合。
- Figure 2-12 shows a high mega-ohm resistor (RDUT) supported on two insulators mounted in a metal test fixture. 图2-12示出了测试夹具上由两个绝缘子支撑的高阻器（RDUT）。
- Again, it may be more economical to cut the cables in half, then permanently connect the cut ends to the test fixture. 同样，若将电缆分为两部分，然后将被截断的一端永久性地连接到测试夹具，则更经济。
- The first step to verify the system requires that resistors of known value be placed in the test fixture. 验证系统的第一步需要将一个已知阻值的电阻器置于测试夹具中。
- This algorithm has been used in the dynamic test system of HJD-28 digital SPC. 采用本文介绍的测试算法设计的测试诊断程序已实际用于 HJD-28用户程控交换机的动态测试系统中.
- If mass-terminated cables are used, mating receptacles can be mounted at the test fixture. 如果采用接线头电缆，在夹具上则可以安装匹配插座。
- Use high-reliability, fail-safe interlock switches to disconnect power sources when a test fixture cover is opened. 采用高可靠性、自动防止故障的联锁开关，在夹具外罩被打开时能够自动断开电源。
- However, it may be more economical to cut mass-terminated cables in half and hardwire the individual wires to the test fixture. 然而，若将接线头电缆分为两部分，然后将独立的导线硬连接至夹具，则更加经济。
- The Model 8009 employs a safety interlock to prevent the high voltage from being applied to the electrode until the test fixture lid is closed. 8009型采用了一种安全互锁机构，在测试夹具的盖子关闭之前，高电压不能施加到电极上。
