您要查找的是不是：
- DC slotless servo motor 直流无槽伺服电机
- Slotted on shaft end ,suitable for DC motor and servo motor. 轴头开槽，适用于直流电机，伺服电机。
- Remove the AC servo motor from the bracket. 从支架上取下马达。
- Attach the new AC servo motor to the bracket. 装上新马达到支架。
- Exchange the servo motor 2HP in spiral. 螺旋交流伺服马达2HP。
- Feed use of the AC servo motor torque of the motor. 进给部分电机采用交流伺服电机转矩大。
- Mill spindle is used by either inverter or servo motor. 铣床主轴采用变频马达或伺服主轴。
- Lathe spindle is used by either inverter or servo motor. 车床可采变频主轴或伺服主轴。
- The DC servo motors are controlled with motion controller LM629 and motor drive chip LMD18200 based on Pc104 bus. 在PC1 0 4总线控制下 ;应用运动控制芯片LM62 9和电动机驱动芯片LMD1 82 0 0实现了直流伺服电动机的控制 .
- The drive is either a three-phase or a three-phase servo motor. 传动机构可以是三相或三相伺服马达。
- Tighten the N coupling nut on the AC servo motor side temporarily. 临时拧紧马达边的N型连接螺母.
- Each slide is driven by a separate ballscrew and AC servo motor. 每张幻灯片是由一个单独的滚珠丝杠和交流伺服电机。
- A multivariable Dynamic Matrix Control algorithm is introduced in this paper, and it is applied to the control of a DC servo motor model. The simulation of DC servo motor DMC control is implemented on Matlab/Simulink. 本文论述了多变量系统的动态矩阵控制(Dynamic Matrix Control,简称DMC)算法的设计和它在多变量直流伺服电机模型控制中的应用,以Matlab/Simulink为平台实现了多变量直流伺服电机的动态矩阵控制仿真。
- I need DC servo motors for CNC engraving machines and CNC routers. Motor must be DC servo with brush, moment from 2-8 Nm ... 查看“机械及工业制品-行业专用机械设备”:公司信息商品信息供应信息
- This paper analyzes a semi closed loep servosystem driven by DC servo motor, discusses how the system and it's building model are affected by the rigidity, nonlinear link and milling force of system. 针对直流伺服电机驱动的伺服进给半闭环系统进行了分析。
- The newly developed cutting unit is also driven by an own servo motor. 新研发的切割机也由自带的伺服马达来驱动。
- CNC system imported from Taiwan and servo motor imported fro japa are adopted. 一、采用台湾进口电脑控制系统和日本进口伺服电机。
- Feeding system adopts CNC servo motor, bending angle uses CNC control. 采用数控伺服电机进料系统，数控折弯角度控制系统。
- New “X” servo motor, new spindle bearings, new pinion &gear drive in 2007. 2007年配新“X”伺服电机，新主轴轴承，新小齿轮和齿轮驱动。
